How do u take the back off an iPhone 4?
How do u take the back off an iPhone 4?
How to remove the back of your iPhone 4
- First remove the bottom 2 dock connector screens in your iPhone 4.
- To remove the back simply slide the back upwards and lift it off gently.
- Set the back and 2 dock connector screws aside.
Does a iPhone 4 have a SIM card?
Locate the SIM tray on the right side of your iPhone 4. It is visible as a recessed rounded rectangle with an internal hole.
Can you open the back of an iPhone 4?
The iPhone 4 is held together primarily with [lots of] screws, sans tabs, and limited adhesive. The rear panel and battery are both easy to remove and replace (provided you have the right kit and/or correct screwdriver). Apple is using Pentalobe screws to secure the rear panel and keep people out.
How do you remove the back cover of an iPhone 3G?
iPhone 3G through iPhone 6 back cover removal If you have an iPhone 3G, 4, 4s, 5, 5s, 5c, SE or 6, you can remove the back cover with a Pentalobe screwdriver and a suction cup. Remove the two screws located on either side of the lightning port, place a suction cup toward the bottom of the front screen, and lift.
How to open the back cover of iPhone 4?
• You can use thumbs and fingers to slide the back plate, or to use small suction cup to pull the rear plate. • Use screwdrivers to remove all screws. Some of screws may hide without notice, thus, be patient during opening iPhone 4 back cover.
Can you take the back off an iPhone and replace it?
If you’re a bit tech savvy and comfortable working with small components, you can take the back off your iPhone so you can replace the screen, charging port or other internal parts. Here’s how to remove the back cover of any iPhone. WARNING: DIY repair risks further damage that could be costly.
How to open iPhone 4 with scuffed screws?
If you do not have proper screwdrivers nearby, here are some small tips you can use to open iPhone 4, with scuffed screws. The one way you can try is to put one elastic or rubber band on the top of the screw, and then remove with screwdrivers. You will find that you can catch the screws again. Or you can use scissor to engrave or enlarger screws.
