Are Celestion 70 80s good?
Are Celestion 70 80s good?
Celestion Seventy 80: Opinion One of the reasons is its great exposure, as it comes in good quality amps. Added to this, they are then compared to other Celestion models that are twice the price, such as the V30, Creamback or G12T75, among others. However, they are speakers that sound great for their value.
How many watts is a Celestion 70 80 speaker?
Celestion Originals
| Eight 15 | Seventy 80 | |
|---|---|---|
| Power Rating | 20 Watts | 80 Watts |
| Nominal Impedance | 4,8 or 16 Ohm | 8 or 16 Ohm |
| Sensitivity | 95dB | 98dB |
| Voice Coil Diameter | 1″ | 1.75″ |
Which Celestion speakers are made in England?
Celestion NOS G12M ‘Greenback’ 16 Ohm — Made in the UK.
Are greenbacks made in China?
Heritage Greenback models are still made in the UK, but the G12M25 reissue Greenbacks are made in China.
Where are Celestion Greenbacks made?
England
Celestion Greenback G12M made in England.
What ohm is best for guitar amp?
You always want to match your amp ohms to the speaker ohms or keep your amp’s ohm output at a lower setting than the ohm of your speakers. If you have an 8-ohm speaker, and your amp is set at 4 ohms, you’ll be okay since your 8-ohm speaker would be able to handle the weaker signal from the amp.
Can I plug a 16 ohm amp into an 8 ohm speaker?
Case 1: running a 16 ohm speaker with an 8 ohm amp output With this combination, the voltage at the speaker output will rise, while the current will almost halve. The power will drop, although you probably won’t notice it too much, as this combination will likely increase the mids in your tone.
Are Celestion Greenbacks made in England?
Here is a G12M Celestion Greenback made in England. The speaker was made in 1999-2000 and has over 300hrs of play in it. The doping removal treatment is the same Badcat and Matchless speakers receive in the factory.
How do you match amp head to cabinet?
Because modern amps have features that allow them to determine the impedance of the speaker cabs, it is best to match two 4 Ω or two 8 Ω cabinets to avoid “confusing” the amp. A “confused” amp may fluctuate in power output and cause damage to the amp. So matching Ω (ohms) in multi-speaker setups is important.
Should guitar speaker wattage be higher than amp?
As a very vague rule of thumb, we normally recommend around twice as much amplifier power as speaker’s power rating. For example, if a speaker is rated at 200 watts, we’d use a 400 watt amp. Again, the idea is to have enough clean power to handle whatever you throw at the amp without clipping.
How does the Celestion seventy 80 compare to the Vintage 30?
The Celestion Seventy 80 has less punch and cut compared with a Vintage 30. This was very evident in a test I did between my Marshall 2×12 cabinet and the Joyo Premium 2×12 Cab. The Marshall was loaded with 2 x 70/80 speakers and the Joyo has the Vintage 30 speakers. Below is a video of this test.
Are Celestion 70/80 speakers bad for 2×12?
Thankfully, it’s not all doom and gloom. Celestion 70/80 speakers aren’t all bad even though so far this post might suggest that. One of the strengths of these speakers is they sound pretty good in a 2×12 cabinet in some situations. One clear situation to avoid using 70/80 speakers is in a Fender amplifier such as a Fender De-Ville 2×12.
Is the Celestion ac4c1 seventy 80?
In some cases, they are not labeled Seventy 80, as is the case with the Celestion VX12 Custom that comes in the AC4C1 with a 12-inch speaker. Let’s look at the top guitar amps that come with this speaker:
What is the best Celestion range to buy?
Finally, for the higher ranges, although you can find a V-Type, usually the top line of Celestion is depending on the character you are looking for: Greenback G12M, or Vintage 30 or G12T75 among others. This serves as a reference to understand the level of not only quality, but also the audio of the Celestion Seventy 80.
