Are snowboard binding plates Universal?
Are snowboard binding plates Universal?
Are all snowboard bindings universal? Despite some bindings being labeled universal, no, they are not. There are some that may fit other designs, some may not. Burton has a unidisc that will fit both 3 and 4 holes, but it is mostly dependent on the model and manufacturer.
Do you have to wax a new snowboard?
If you are wondering do I need to wax a new snowboard? Yes, you should so go get it the wax job it deserves. Your snowboard will perform better with the correct wax for your snow conditions. It will have a solid layer of wax soaked into the bases to protect it from water.
Can any bindings fit on a Burton board?
Boards with this pattern will work with any binding of any brand except the Burton EST bindings. The Burton EST bindings are specifically designed for the Burton Channel System which we will get to a little later. Again, any non EST binding will mount to any normal 4 Hole Pattern Snowboard.
Do Burton disc bindings work with 4 hole pattern boards?
As you can see below, regular Burton disc bindings (non EST bindings) will work with 4 Hole Pattern boards. These bindings will come with the appropriate discs for mounting. Again, any non EST binding will mount to any normal 4 Hole Pattern Snowboard.
What do I need to Mount Burton M6 disc bindings?
If you purchased 2011 Burton disc bindings, now with of the use of the new M6 channel, you can actually mount these using the M6 hardware that comes with the board. The disc included with the binding along with the new M6 hardware is all you need.
What are the Burton est bindings made for?
The Burton EST bindings are made to work exclusively with the channel system. These bindings utilize a screw on the inside and a screw on the outside of the binding which are then screwed directly into the channel. These bindings do not have discs and again are ideal to be used with Burton ICS boards.
What does the Burton 3-D pattern look like?
As you can see from the diagram below, the Burton 3-D Pattern looks a little different than the normal 4 Hole Pattern. This 3-D design is used exclusively by Burton, and uses only 3 screws in a triangular pattern to mount each binding.
https://www.youtube.com/watch?v=UYCy9ZUz3-I
