Can a fuel injector be stuck open?
Can a fuel injector be stuck open?
An injector that is stuck open or partially closed will emit an unburnt fuel odor in the engine compartment. A dead injector will cause the engine start and operate when it is cold but not when it is warm.
What do I do if my drill chuck is stuck?
If the chuck is stuck open, check that the screw inside the drill chuck is fasten tight. If it is loose, it can prevent movement of the teeth. To solve this problem, insert the proper screwdriver in the drill chuck and tighten. Remember, this screw is reversed thread so turn it counter clockwise to tighten.
Why does my drill bit get stuck?
If the drill got stuck and a regular wrench worked, then the only possible explanation I can think of is that your drill lacked the power to continue the full length into the wood. This is perfectly likely if you had a large bit which was getting dull and a cordless drill with an inadequate charge to it.
How do you replace the Chuck on a Milwaukee cordless drill?
How to Replace the Chuck on a Milwaukee Cordless Drill. Open the chuck to the widest position. Use a Phillip’s screwdriver to loosen the retaining screw. The screw is reverse-threaded (requiring clockwise rotation to loosen). Remove the screw from the chuck assembly.
Why is the Chuck stuck open on my drill?
If the chuck is stuck open, check that the screw inside the drill chuck is fasten tight. If it is loose, it can prevent movement of the teeth. To solve this problem, insert the proper screwdriver in the drill chuck and tighten. Remember, this screw is reversed thread so turn it counter clockwise to tighten. If…
How do you remove the Chuck from a craftsman drill?
REMOVING THE CHUCK [top] 1. Remove the battery from the drill. 2. Switch the transmission to the lowest setting. Slide the gear selector switch to the lowest setting. 3. Set the clutch to the Drill setting. Rotate the clutch assembly to the Drill setting. 4. Remove the chuck retaining screw. Open the chuck to the widest position.
What should I do if my drill bit is stuck?
Using your hand (protected with a glove) or a strap wrench, run the drill in reverse until the bit comes loose. If the bit is still stuck the chuck may need to be replaced. Transmission slips on one or both speeds. If the transmission slips on any of the speed settings, it is possible the gear case assembly is damaged and needs to be replaced.
