How do I configure a port on a Cisco switch?
How do I configure a port on a Cisco switch?
About This Article
- Connect to the switch.
- Run the enable command.
- Run the configure terminal command.
- Run interface port-id (replacing port-id with the port you want to enable).
- Run the “no shutdown” command.
- Run “copy running-config startup-config” to save your changes.
Is there a GUI for Cisco switches?
A web browser, or graphical user interface (GUI), is built into each switch. You can use either the service port interface or the management interface to access the GUI. We recommend that you use the service-port interface.
How do I assign an IP address to a Cisco switch?
Configure an IP address on a switch
- enter the VLAN 1 configuration mode with the interface vlan 1 global configuration command.
- assign an IP address with the ip address IP_ADDRESS SUBNET_MASK interface subcommand.
- enable the VLAN 1 interface with the no shutdown interface subcommand.
How do I reset my Cisco 2960 router to factory settings?
Procedure to reset a Cisco 2960 (or 2950) to factory defaults by deleting the configuration files. Connect the blue console cable, and open a TTY session: 9600,8,n,1. – Hitting return should give a prompt, confirming the connection. Press and hold the front panel MODE button, and power-up the switch.
How do I see active ports on a Cisco switch?
You can display summary or detailed information on the switch ports using the show port command. To display summary information on all of the ports on the switch, enter the show port command with no arguments. Specify a particular module number to see information on the ports on that module only.
What is the purpose of a Cisco 2960?
The Cisco Catalyst 2960 Series Switches with LAN Base Software offer the following: Dual-purpose uplinks for Gigabit Ethernet uplink flexibility, allowing use of either a copper or fiber uplink; each dual-purpose uplink port has one 10/100/1000 Ethernet port and one SFP-based Gigabit Ethernet 24 or 48 ports of Fast Ethernet desktop connectivity PoE configurations with up to 15.4W per port
Does Cisco 2960x support WCCP?
“WCCP will support on WS-C2960X-48TD-L switch?” According to the Cisco website, Cisco 2960X WS-C2960X-48TD-L doesn’t support WCCP, but 2960XR with IP base or IP services license .
What are the ports on Cisco Catalyst switches?
Mount in wall or on desktop
What are the commands for Cisco switches?
Cisco Switch Configuration Commands. Configure terminal: This command is used to enter the global configuration mode of the Cisco switch. Hostname: This command assigns the Cisco switch’s hostname. Enable password: This command sets the enable password of the Cisco switch.
