How do I fix F05 fault Indesit?
How do I fix F05 fault Indesit?
Indesit error F05 or F11
- Prepare a towel or a bucket.
- On the front side of the machine, open the hatch in front of the drain filter and unscrew the filter.
- Drain the excess water and collect it.
- Check if there’s a pin, coin or button in the drain and remove it.
- Clean and replace the drain filter.
What does fo5 mean on a Indesit washing machine?
Waste pipe blockage
F05 — Waste pipe blockage or pump issue. Issue: Washing Machines door will not open / the door can be opened but water remains inside the drum.
What does F 05 mean on washer?
What does F 01 mean on a washing machine?
failed electronic machine control board
The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes. Be sure to unplug the washer before accessing internal components.
How do you do a factory reset on a washing machine?
If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved.
How do I reset my electric washing machine?
To reset your washing machine, unplug it from the power outlet. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
What does WF mean on an Indesit thermostat?
As Indesit and Hotpoint are made by the same company some Hotpoint models also use this error code (WF and WD models). This error code usually means, “heater relay stuck”. The heating element is switched on via a relay. The relay is built into the main PCB.
How do I Reset my Indesit washing machine?
Check out the following points to reset your Indesit washer. Firstly, unplug the machine. To turn the machine on, press the “on / off” button. The display’s LEDs should now be flashing. Turn the machine off by pressing the on/off button. Choose the needed program.
Why is my Indesit washing machine not spinning?
Drain pump failure, drum nut loosening, malfunctioning door locks, suspension wear out, and a damaged plastic bracket at the back of the machine are some other reasons for the machine not spinning. 3) My Indesit washing machine is leaking This is one of the most prevalent causes in the old washer.
Why is my Indesit washer leaking water?
Make sure the door of the washer is fully tight. Your Indesit washer will also cause leakage if you use too much detergent or a poor quality detergent in it. Excessive foam overflow might occur if you use too much laundry detergent. To keep the machine from leaking, try reducing the amount of detergent or switching brands.
