How do I open my Logitech remote?
How do I open my Logitech remote?
Remove battery
- Open the USB port cover and use a #0 Phillips screwdriver to remove the two screws.
- Remove the end cap and two screws on the underside of the remote, you should now be able to lift the baseplate.
- Lift the battery and disconnect the cable to remove the battery from the remote.
How do I charge my Harmony remote?
Your Harmony 700 comes with an AC adaptor for charging the batteries in your remote. To recharge the batteries, just insert the USB cable into the top of the remote, plug the other end of the cable into the AC adaptor, and then plug the AC adaptor into a wall outlet and charge.
How do I remove a device from my Harmony One remote?
Launch the Harmony app and sign into your account. Select your Harmony remote, followed by the device you would like to delete. Scroll to the bottom of the screen and select DELETE THIS DEVICE > DELETE.
How do you open the Harmony ultimate one?
Use a plastic opening tool to release tabs that hold the front panel and back panel together. There are three tabs on each side of the device that need to separate for the device to open. The use of a plastic opening tool is recommended to avoid damaging the remote.
How do I clean my Harmony elite remote?
Dip a cotton swab in the rubbing alcohol and remove any excess liquid. Use the damp cotton swab to wipe around the buttons and along the seam. Switch to a fresh cotton swab as needed. Clean the back of the remote the same way, using a cloth instead of a swab if preferred.
What cable do I need for Harmony remote?
USB cable
The USB cable that was included with your Harmony remote. Any ‘5-Pin Mini-B’ USB cable will work for almost all Harmony remote controls. The Harmony 600, 650 & 700 require a ‘Micro-B’ USB cable. You may even have a spare one from most digital cameras, mp3 players or cell phones.
How do I get my Harmony remote to work?
To reboot your Harmony blaster, disconnect the power cable and wait 10 seconds, then connect it again. It will take about 30 seconds to power back on. The following tips may also be helpful: If your remote is blinking red, it needs to be charged until the light turns solid white.
https://www.youtube.com/watch?v=L6S73TlScXA
