How do I pause a batch file for a certain amount of time?
How do I pause a batch file for a certain amount of time?
About This Article
- To pause until a key is pressed, use “PAUSE.”
- To wait a specific amount of time, use “TIMEOUT.”
- To wait for a ping response, use “PING” followed by the IP.
How do I pause a batch script?
Execution of a batch script can also be paused by pressing CTRL-S (or the Pause|Break key) on the keyboard, this also works for pausing a single command such as a long DIR /s listing. Pressing any key will resume the operation.
How do I pause seconds command?
Delay execution for a few seconds or minutes, for use within a batch file. Syntax TIMEOUT delay [/nobreak] Key delay Delay in seconds (between -1 and 100000) to wait before continuing. The value -1 causes the computer to wait indefinitely for a keystroke (like the PAUSE command) /nobreak Ignore user key strokes.
How do I press a button in a batch file?
Usually either tabs and/or arrow-keys will suffice. Sometimes you may need to use the ALT key to move into the menus. Also, you might actually be able to use a series of keyboard commands like ALT + F S ENTER , or even a keyboard shortcut like CTRL + S .
How do I keep cmd from running after a batch file?
Depending on how you are running the command, you can put /k after cmd to keep the window open. Simply adding cmd /k to the end of your batch file will work too.
How do you make a batch file not close?
If you’re creating a batch file and want the MS-DOS window to remain open, add PAUSE to the end of your batch file. This prompts the user to Press any key. Until the user presses any key, the window remains open instead of closing automatically.
How do I press the key to continue in CMD?
One of the easiest to use is the pause command. Place this in your batch file, and when it’s reached, the Command Prompt throws up a ‘Press any key to continue’ message, and waits for a key to be pressed.
How do I loop a batch file in Windows?
- Take a set of data.
- Make a FOR Parameter %%G equal to some part of that data.
- Perform a command (optionally using the parameter as part of the command).
- –> Repeat for each item of data.
