How do I reset my Cisco phone 7942?

How do I reset my Cisco phone 7942?

Performing the Factory Reset on Cisco 7942, 7962 IP Phones

1. Unplug the power cable from the phone and then plug it back in. The phone begins its power up cycle.
2. While the phone is powering up, and before the Speaker button flashes on and off, press and hold #.
3. Release # and press 123456789*0#.

How do you do a soft reset on a Cisco phone?

To perform this process do the following steps:

1. Unplug the power cable and/or the switch cable if using PoE.
2. Plug the device back in, pressing and holding the “#” key before the Speaker button flashes on and off.
3. Continue to hold the # button until each line button flashes on and off in sequence (amber).

How do you reset a Cisco VoIP phone?

Press and hold # button while plugging the phone back in. Press 123456789*0# in sequence. After you press these buttons, the phone goes through the factory reset process.

How do I hard reset my Cisco phone?

A hard factory reset restores all settings to factory default, including network and security settings.

1. Unplug the Ethernet cable from the phone.
2. Holding the microphone button, power on the phone by plugging in the Ethernet cable.
3. Press and hold the microphone button for about 5 seconds then release it.

How do you reset a VOIP phone?

Enter the admin password to proceed with the factory reset. The password is 456 by default. In the phone, navigate to Menu > Config > Factory Reset. Enter the MAC address of the phone and press OK to proceed with the factory reset.

How do I reset my Cisco phone remotely?

Simply add /admin/reboot to the phone’s IP in web URL (e.g. http://192.168.0.51/admin/reboot) and providing there are no active calls, phone will reboot.

How do you restart a CUC server?

Step 1 From the Cisco Unified Communications Operating System Administration window, navigate to Settings> Version. The Version Settings window displays, which shows the software version on both the active and inactive partitions. Step 2 To restart the system, click Restart, or to stop the operation, click Cancel.

How to set up voicemail on Cisco IP phone 7942?

How do I set up Voicemail on Cisco IP Phone 7942? Press the Unity Voicemail button on your Cisco IP Phone or dial 85555 and enter your PIN (12345) when prompted. Allows you to save a recorded name Set up a voice greeting Change your PIN or password.

How do you factory reset a Cisco router?

To reset your router to its factory default settings using router commands Follow below steps: First switch on your Cisco Router. Then, connect your PC or Laptop to the console port on your router with the console cable. After that, power on the router and wait 5 to 7 minutes for the router to finish booting. You can check the lights on the router.

How do you factory reset a Cisco phone?

Performing the Factory Reset on Cisco 7920 Wireless IP Phone. To reset a Cisco 7920, the ip phone must be started in administration mode using the following steps: Press the Menu softkey. Press * (star), # (hash) and * (star) again. Press the Green phone key (used to answer a call) to open the administration mode.

How to reset Cisco phone?

Step 1. Press the Applications button on the front of the phone.

Step 2. Scroll down and select Device administration > Select . To scroll down you use the Navigation button as shown here.

Step 3. Scroll down and select Factory Reset > Select .

Step 4. Scroll down and select OK .