How do I reset my hunter thermostat?
How do I reset my hunter thermostat?
Press and hold the Programs button, and at the same time press in the recessed Reset button with the tip of a ballpoint pen. Release the Reset button and continue holding the Programs button until the Reset Memory screen appears (then release the Programs button).
What does a flashing 3 mean on a Hunter thermostat?
A flashing 3 means the third setting is currently operating the heater or AC.
How do you reprogram a hunter thermostat?
Step 2: Program the HEAT Setting
- Slide the SYSTEM SWITCH button to the HEAT setting.
- Press PROGRAM.
- Use the UP/DOWN arrow keys to select the hour you want the first program to begin.
- Press the PROGRAM key again.
- Use the UP/DOWN arrow keys to set the minute you want the first program to begin.
- Press PROGRAM again.
How do I reset my hunter thermostat 44155c?
SETTINGS
- Press and hold the Up button.
- Use a paperclip to press the Reset button.
- Continue to press the Up button, but release the Reset button when the LCD turns on.
Why is my hunter thermostat not working?
If the thermostat is failing to activate the air conditioner or heating unit as desired, first be sure the selector switch is in the correct location. If you are still having problems, turn off power to the thermostat, remove its faceplate and confirm that the wires are connected to the proper terminals.
How do you use a hunter touchscreen thermostat?
How to Program Hunter Touchscreen Thermostats
- Touch the screen while it is in sleep/ready mode to turn on the Hunter thermostat.
- Tap the day that you want to set a program for on the screen.
- Touch the “Heat” or “Cool” icon to select the system you want to engage.
Why is the auto on my thermostat not working?
Switch the thermostat setting to “Fan Auto.” Turn off the power, then check to make sure there isn’t a short in the wiring. Also make sure that the wires for the thermostat and furnace/air conditioner aren’t touching together. Check your thermostat’s batteries.
How do you change the battery in a hunter thermostat?
How do I Replace a Hunter Douglas Thermostat Battery?
- Lift the front cover of the thermostat upward.
- Push the battery release latch inward and upward to remove the battery housing unit cover.
- Insert two AA 1.5-volt batteries.
- Slide the battery housing unit cover over the batteries and back into position.
What systems does the Hunter Fan thermostat work on?
This thermostat is designed to work on the following systems: ENERGY STAV PARTNER As an ENERGY STARS Partner, Hunter Fan Co. has determined that this programmable thermostat meets the ENERGY STAV guidelines for energy efficiency.
What if my Hunter thermostat has a hole in the wall?
If you require further assistance, call Hunter Technical Support at 1-888-830-1326 from 8am to 5pm Central Time. If hole in wall is larger than necessary for wires, seal this hole with insulating material so that no hot or cold air can enter the back of the thermostat from the wall.
What is the span setting on my thermostat?
SPAN Setting Mode Your thermostat is set at the factory to cycle at 1˚F (0.5˚C) above and below the set tempera- ture. (Span = 2) This setting has been designed to provide a comfortable room temperature under most all conditions. Auto Cut Off Your thermostat will automatically cut-off in Heat mode if the room temperature rises above 95˚F (35˚C).
How do I change the time on my thermostat to 24 hours?
To change to 24 hour (military) time, press program at any time while the Hour, Minute, or Day is flashing to toggle between the 12 hour and 24 hour formats. 3 seconds. SPAN Setting Mode Your thermostat is set at the factory to cycle at 1˚F (0.5˚C) above and below the set tempera- ture.
