How do I reset my Jenn-Air microwave?
How do I reset my Jenn-Air microwave?
Reset power to the product:
- Power unit down by turning off the circuit breaker(s) for one (1) minute.
- Power unit up by turning on the circuit breaker(s).
- Start a bake cycle.
- Monitor the oven for one (1) minute to ensure the error code does not display again.
- Verify oven operation.
Why is my microwave blank?
Check the Power Supply The first step for any appliance troubleshooting is to check the power cable and power supply. If the screen has gone completely blank and the buttons don’t beep anymore, there’s a chance that your microwave is just unplugged or is powered by a tripped breaker.
Why did my microwave all of a sudden stop working?
The most common cause for a microwave oven not working at all is a blown main fuse. The microwave main fuse will cut the flow of electricity if too much current passes through it. There can also be thermal fuses, cavity fuses, and thermoprotectors which will interrupt the electrical flow if the microwave overheats.
How do I change the lightbulb in my Jenn-Air microwave?
How to Replace the Interior Light Bulb on an Over the Range Jenn-Air Microwave
- Unplug the Microwave or disconnect power.
- Remove the two screws on the top of the vent grille, tilt the grille forward, and lift it out.
- Open bulb cover and replace bulb with an incandescent style light bulb.
How do you unlock a Jennair microwave?
Press and hold the CANCEL keypad for 3 seconds. Two (2) tones will sound and “LOC” or a padlock icon will be displayed (indicating the control is LOCKED). Repeat to unlock.
How do you know if your microwave fuse is blown?
To check a ceramic fuse, use an ohmmeter or continuity tester. With an ohmmeter or multimeter, you should see a reading close to zero ohms if the fuse is intact, or infinite if it’s blown. If a continuity tester indicates continuity when you touch its lead to the ends of the fuse, it’s good.
Where is the microwave fuse?
Fuses are located in many places inside the microwave, including the top, side, and behind the vent grille. Using the wiring diagram can help you locate the appropriate fuse. Once you have located the fuse, remove any necessary wires and fasteners to free it from the microwave.
Where are microwave fuses located?
How do I change the light in my microwave?
Behind the Microwave
- Turn your microwave around.
- Grab the screwdriver and remove mounting screws around the edge of the microwave back panel.
- Carefully pull the cabinet cover away from the top and sides.
- Find the light bulb cover and remove the mounting screws.
- Remove the old bulb and replace it with the new light bulb.
How do you change a lightbulb in a Frigidaire microwave?
First, unplug the microwave or turn off the power at the main circuit breaker. Then, remove the the bulb covering mounting screws at both positions under the microwave. Remove and replace the old bulbs with 30-watt appliance bulbs. Reinstall the bulb cover and mounting screws.
How do you unlock the Jenn Air oven control panel?
Turn the power off at the circuit breaker or fuse box for one minute, then turn the power back on. Allow the oven to cool, approximately 30-90 minutes, move the latch arm to the left to unlock the door.
