How do I reset my Ruckus AP to factory settings?
How do I reset my Ruckus AP to factory settings?
Insert the power supply into the access point while holding the RST button. Hold the RST button for approximately 15 seconds. The access point will be reset to factory settings.
How do I reset my Ruckus AP from command line?
Log-in to the AP CLI using Putty application. set factory is the command to reset the Standalone AP to factory default settings.
How do I reset my ruckus H510?
Use a straightened paper clip to press and release the Hard Reset button for eight seconds or more to reset the AP to factory defaults. Use a straightened paper clip to press and hold the Soft Reset button to reboot the AP. This is the same as removing power and then and restoring power to the H510.
How do I reset my Ruckus WiFi?
Go to Admin & Services > Administer > Backup & Restore. Click Restore to Factory Settings. Click OK to confirm. The Restoring Unleashed to factory settings progress screen appears.
What commands are required to perform a factory reset on a switch?
To reset the switch to factory default, issue the erase startup-config or write erase command. This command does not clear the boot variables, such as config-register and boot system settings. You can alter the boot system parameters with the boot command.
How do I reset my switch settings?
Hold the “mode” button on the front of the switch for 10 seconds. The lights will blink then go solid – the switch completely wipes all configuration and then reboots.
How do I know if my ruckus has warranty?
To determine which Hardware warranty applies to the Product(s) you purchased, and for additional information relating to your warranty, please refer to the warranty checker utility which can be found at Ruckus’ support website at: support.ruckuswireless.com.
How do you reset a network switch?
For instructions, follow the steps below:
- Access the web interface of your switch.
- Click on the Reset option located at the upper-right corner of the web interface.
- Click OK.
- Access the web interface of your switch.
- Click on the Reboot option located at the upper-right corner of the web interface.
- Click OK.
