How do I reset my VT?
How do I reset my VT?
Press and hold the up and down arrow buttons simultaneously on the trip computer control panel. 3. Switch the ignition on while continuing to hold down both buttons 4. Release the buttons when a beep is sounded from the dash (reset will be flashing).
Is a VT a Commodore?
The Holden Commodore (VT) is an executive car that was produced by Holden from 1997 to 2000. It was the first iteration of the third generation of the Commodore and the last one to be powered by a locally made V8 engine (1999).
How do you reset a VT Commodore computer?
Turn ignition off. Hold down the UP and DOWN buttons of the trip computer. Turn the ignition on while still holding down both buttons. Release the buttons after 3 seconds (RESET will be flashing).
How do portable jump starters work?
Portable jump starters transfer power directly from the portable battery to a vehicle’s discharged battery. These devices work by connecting special booster cables directly into a 12-volt power port on one end and to a car battery using clamps identical to traditional booster cables on the other end.
Where is the crank angle sensor on a VX Commodore?
Crawl underneath the engine and locate the crank angle sensor. It is in the center of the engine block, between the firewall and the engine. It is made from black plastic and has a two-wire connector attached to it.
What do you do when your car won’t jump start?
If the car starts right away, your problem is most likely a dead battery. Charge the battery and clean the terminals and cable connectors to ensure good contact. If your car does not start by jump-starting, you may have a problem with your starter, alternator or another component of the electrical system.
Why does my VT have no fuel pressure?
Some VT’s that will not start, and have no fuel pressure, may have poor terminal connection on the fuel pump circuit inside the fuel sender unit assembly.
Why is my starter motor not working after replacing?
Even after a new starter motor has been fitted, some cars still experience slow cranking speeds when the engine is warm. The main cause of this has been traced to excessive current draw from the battery harness (thanks to heat, and a once poorly operating starter). Once the battery harness has been replaced cranking speed is improved.
Why won’t my V8 V8 restart?
Some VT V8’s (5.0ltrs) may not restart if the ignition switch has not been returned to the off position (like during a short stop where the key is not removed). Revised Memcals were introduced to eliminate this problem. 3.
Why won’t the starter motor tighten on my Kenmore dryer solenoid?
The solenoid has a bakelite insulator where the cable poles connect, and through age and heat, the bakelite insulator becomes loose. They cannot be tightened, as they are crimped into the solenoid housing. A new solenoid/starter motor is usually required.
