Other

How do I set management interface on Juniper switch?

author 0

How do I set management interface on Juniper switch?

To configure a management port by CLI commands.

  1. Use the command “family inet address” to configure a management IP address on the interface.
  2. Configure a static route with the next hop to the management network default gateway set routing-options static route 0.0.0.0/0 next-hop 10.93.15.1/21.

What does a management interface do?

2.1 The Basics of Management Interfaces. Management interfaces allow network operators to manage the devices in their networks by providing access to each device’s control, configuration, and status information. The management interface provides a consistent external view of the manageable objects in a device.

What is management network interface?

In computing, a management interface is a network interface dedicated to configuration and management operations. This greatly reduces the attack surface of the managed devices, as external attackers cannot access management functions directly, and thus improves network security.

What is the default management interface?

The management interface is the default interface for in-band management of the controller and connectivity to enterprise services such as AAA servers. It is also used for communications between the controller and access points, for all CAPWAP or intercontroller mobility messaging and tunneling traffic.

How do I enable Juniper interface?

Enable/Disable Interface in Juniper

  1. root@Juniper# set interfaces ge-0/0/1.0 disable << This is cisco equivalent of “shutdown” – To Juniper enable interface:
  2. root@Juniper# delete interfaces ge-0/0/1.0 disable << This is cisco equivalent of “no shutdown” Verification:
  3. root@Juniper#show ge-0/0/1.0.

What is em0 interface in Juniper?

em0 and em1 are the internal interfaces on the Routine Engine (RE). em0 is the interface connected to the Ethernet switch on the local Switch Control Board (SCB). em1 is the interface connected to the Ethernet switch on the other SCB.

What is fxp0 interface in Juniper?

The fxp0 interface on Juniper routers is expressly designed to be an ‘out-of-band’ management port for your router. It is not designed to support or be configured with advanced features that many other Juniper PIC’s are designed for.

What is out of band management Juniper?

Out-of-band management is handled through special management interfaces on Juniper Networks devices. These interfaces are Fast Ethernet interfaces located on the front of all Juniper Networks devices. This setup separates management traffic and network traffic.

How do I find my interface configuration in Juniper?

To display the current configuration for a Juniper Networks device, use the show command in configuration mode. This command displays the configuration at the current hierarchy level or at the specified level.

How do I disable BGP on Juniper?

disable (Protocols BGP)

  1. Syntax. content_copy zoom_out_map. disable;
  2. Hierarchy Level. content_copy zoom_out_map.
  3. Description. Disable BGP on the system.
  4. Required Privilege Level. routing—To view this statement in the configuration.
  5. Release Information. Statement introduced before Junos OS Release 7.4.

author

Back to Top