How do I wire Axswc?
How do I wire Axswc?
Connect the Redwire to the accessory power. Locate the steering wheel control wire(s) in the vehicles harness as noted in the AXSWC vehicle specific document. Connect this wire(s) to the AXSWC. Note: Axxess recommends that the wires are soldered for the best “copper-to copper” connection.
How do you change the radio on Aswc 1?
Press and hold the Volume Downbutton on the steering wheel until the ASWC-1’s light turns on solid Red, then release. The light will then go out indicating that the ASWC-1 is in Changing Radio Typemode.
What is a Axxess?
Metra Axxess Universal Steering Wheel Control Interface Updateable via a common micro B USB cable to ensure you have the most up to date inventory. Non volatile memory retains the steering wheel control settings even if the battery is disconnected or the ASWC-1 is removed from the vehicle.
How do I install the aswc-1?
you’re ready to install the ASWC-1. Installing the ASWC-1 1) Connect the Black wire of the ASWC-1 to ground. You may use the same grounding point as the aftermarket radio. 2) Connect the Red wire of the ASWC-1 to a 12-volt accessory wire, one that turns “On” and “Off” with the ignition key.
How do you wire an aswc-1 to a car?
ASWC-1 VEHICLE SPECIFIC INSTRUCTIONS ASWC-1 Connections: Connect the Black wire of the ASWC-1, and the wire in Pin 19 of the vehicle’s harness shown, to Chassis Ground. Connect the Red wire of the ASWC-1 to 12v
How do I Find my axswc instructions?
If you are looking for AXSWC instructions, you’ll need to use the vehicle fit guide to enter in your vehicle make, model, year and trim options, as these instructions are specific to the vehicle you are installing it on. Click get parts and you’ll see your AXSWC instructions at the top.
How do I reset the aswc-1 to factory settings?
Turn the ignition on, then press and hold the Reset button on the ASWC-1 for approximately 10 seconds until the LED on the ASWC-1 flashes slow; and then release the Reset button.
