Trending

How do you clear the alarm on Rainbird ESP?

author 0

How do you clear the alarm on Rainbird ESP?

The status light on the module of the shorted station will blink continuously. Remove the shorted station wire from the module. In the Auto dial position select Alarm and Clear.

Why is my rain sensor flashing?

If the LED is flashing, the selected Transmitter location is within range. The rainfall setting determines the amount of rainfall needed to prevent your irrigation system from watering.

How do I reset my Rain Bird controller?

Turn the dial to Seasonal Adjust. Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen. Your ESP-Me is now restored to the factory default settings.

How do I turn off Rainbird ESP me?

Starts here0:53How To Turn On/Off The Master Valve On A Rain Bird ESP-ME – YouTubeYouTube

How do you test a Rainbird sensor?

For a cork-disc sensor:

  1. Locate the rain sensor for your irrigation system.
  2. Turn on the time clock for the zone nearest the sensor.
  3. Press and hold down the button on top of the sensor.
  4. Release the button and the zone should come back on.
  5. If the system does not shut off or come back on, check for wiring problems.

How do I know if my sprinkler solenoid is bad?

Signs You Have a Problem

  1. The Water Won’t Shut Off. If you have this problem, it’s very likely the solenoid.
  2. Low or Uneven Water Pressure. The solenoid controls the water pressure.
  3. Water Leaks. There are many points in a sprinkler system that can leak.
  4. Current Testing.
  5. Valve Inspection.
  6. Parts Replacement.

What is the Rainbird controller password?

The controller password is restricted to letters and numbers, 4-8 digits in length. No special characters. If you use a special character it will not be registered in the password. As an example, if you typed in 1234@, the password would be stored as 1234.

How do I reset my automatic sprinkler system?

How to Reset a Sprinkler System

  1. Turn the control dial to the “off” position.
  2. Press the “next” button to access the clear-memory feature.
  3. Press and hold the “off” button until the display stops blinking.
  4. Turn the control dial to the “run” position.
  5. Press and hold down the “minus” arrow and “prog” buttons simultaneously.

author

Back to Top