How do you test an electric dog fence?
Here is how to do a short loop test:
- Unplug all wires going into your dog fence transmitter.
- Cut a small piece of wire (12 inches) and strip both ends of it.
- Connect each end to your two terminals going into your dog fence transmitter, creating a tiny little loop.
- Plug in your dog fence transmitter.
Why is my invisible fence not working?
My pet’s Invisible Fence collar doesn’t activate at the boundary, what is wrong? Ensure that your pet’s Computer Collar receiver is fitted properly to his neck. The collar should be snug enough to slide only one finger between a correction post and your pet’s skin.
How do you reset an electric dog fence?
Resetting the system can be as simple as replacing the batteries in your transmitter. Bring your dog inside, and turn off the power to the fence. Unplug the transmitter. Look for metal objects around or on top of the fence.
How do I find the invisible wire in my fence?
How to Find Buried Invisible Fencing
- Make sure your invisible fence is plugged in and turned on. You should see an indicator light on the radio transmitter unit confirming this.
- Find the radio frequency that your invisible fence is using.
- Walk through your yard with the AM radio tuned to the correct radio frequency.
How do you find a broken invisible fence?
Take an extra length of wire and run it over a section of underground wire. Carefully dig out the underground wire at both ends of the run. Cut the underground wire at both ends and connect the above-ground wire to make a bypass. If the transmitter stops beeping you found the break.
How do you test if invisible fence is working?
Replace the Batteries Some invisible pet fences include a battery tester with the fence system. Place this on the collar and walk past the boundary wire. If the tester lights up and you hear the audible warning given by the collar, the battery is functioning properly.
How do I program my invisible fence?
How to Change the Strength of an Invisible Fence
- Push the button on the receiver. A light on the receiver will flash.
- Adjust the distance from the boundary wire to trigger a warning alarm. Most transmitter boxes have a knob or lever to use to change the distance.
- Change the metal prongs on the receiver.
How deep do you put invisible fence wire?
How Deep Should I Bury Invisible Fence Wire? Bury the wire 3 to 5 inches. This is deep enough to protect it from the elements and animals but shallow enough to maintain a strong signal.
What to do if your dog fence collar is not working?
Check to make sure the collar battery is inserted positive end facing upward. Try resetting the frequency of your dog fence collars, to a setting of 01 on your transmitter. Try testing the collar by holding it at the height of your dog’s neck, which is around your knees. Is any part of your boundary loop still wound around your wire spool?
Why is my Dog Fence not connecting to the House?
You have to walk in and then back out again to test. Another possibility is that you are piggybacking a utility line. This can happen if you don’t separate your dog fence wire from your utility lines by 4 feet when running parallel. Is your wire positioned too close to the house?
Are invisible fences bad for dogs?
Wild animals, cats, other dogs or even people (especially children) can easily wander into your yard, which can result in injuries to everyone involved. Invisible fences also do little to protect dogs from being stolen or harmed by people with bad intentions. 5. Electric shocks can induce fear, anxiety and aggression.
How to adjust the frequency of a dog fence collar?
You can adjust it up or down from there. Check to make sure the collar battery is inserted positive end facing upward. Try resetting the frequency of your dog fence collars, to a setting of 01 on your transmitter. Try testing the collar by holding it at the height of your dog’s neck, which is around your knees.