How long does it take to remove a drive shaft?
How long does it take to remove a drive shaft?
even a novice should have it done in about 2-3 hours taking your time and following the manual.
How do you remove a driveshaft from a transfer case?
Move to the transfer case end of the drive shaft. Locate the four retaining bolts, remove them with a wrench and pull the shaft off the transfer case. You may need to rotate the drive shaft to get to all the bolts. Shift the transfer case into neutral, allowing it to spin freely.
How does a driveshaft disconnect work?
When disconnected, the rear axle is free to turn without turning the driveshaft or transmission. The system is engaged via a control cable that extends to a location underneath the driver’s seat; the cable is pulled out to disengage and pushed in to re-engage.
What happens if you dont mark your drive shaft?
If they split the shaft and not re install it correctly, they will throw the shaft out of balance and cause an uncomfortable vibration. One piece shaft guys have the slip yoke in the t-case, so they dont have to worry about any of this.
How do you remove the drive shaft from a Chevy Silverado?
Wrap electrical tape around the ends of the u-joint to keep the caps from falling off. Place the third jack stand under the front end of the driveshaft. Grab the shaft and pull it towards the rear of the Silverado until it pulls out of the transmission.
How do you remove the U-joint from a Chevy Silverado?
Use caution to prevent the u-joint from falling out of the yoke. Wrap electrical tape around the ends of the u-joint to keep the caps from falling off. Place the third jack stand under the front end of the driveshaft. Grab the shaft and pull it towards the rear of the Silverado until it pulls out of the transmission.
How do you remove the transmission from a Chevy Silverado?
Place the third jack stand under the front end of the driveshaft. Grab the shaft and pull it towards the rear of the Silverado until it pulls out of the transmission. Shove the rag into the transmission to keep dirt out.
How to replace the rear axle on a Chevy Silverado?
Lift the Silverado’s rear end with the floor jack and support it on two jack stands, placed under the rear axle out near the spring perches. Slide underneath with the socket set and tape.
