How many lugs does a Dana 60 have?

How many lugs does a Dana 60 have?

We know that almost all OEM 60s are 8 lug.

Are all Dana 60 front axles the same?

There are three major variations of the Dana 60 axle used in the 1960s to 1980s. GMC, Chevy, and Jeep are all basically the same. There are three major variations of the Dana 60 axle used in the 1960s, 70s, and 80s: Dana 60 axles on the GMC, Chevy, and Jeep are all basically the same.

How do I identify my Dana 60 axle?

Many Dana axles have the model ID cast into the fins or centersection. Look for a “44” or “60” cast into the reinforcement ribs. The number can usually be found on the lower right side rib below the differential cover, but it may also be found on other ribs or on top of the main cast structure.

What years axle was the 05 Dana 60 used on?

Ford used Dana Super 60 Front Driving Axles in 2005-2016 F250, F350, F450, and F550 Super Duty 4×4 trucks. Each axle is built with a Bill of Material (BOM) Tag affixed to the differential cover by two cover bolts.

What vehicles have Dana 60 axles?

The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.

What is the difference between a Dana 60 and a Super 60?

The Dana Super 60 is an upgraded version of the Dana 60 axle. Differences in the Dana Super 60 versus the regular Dana 60: Larger and thicker diameter steel tubes (3.75 inches diameter and ½ in thick) Larger ring and pinion which increase the contact area and overall strength.

How can I tell what is a Dana 60?

Specifications. The Dana 60 was made in a full-floating and semi-floating configuration. The Dana 60 usually has a 30-spline axle shaft.

Vehicles. The Dana 60 was used by all American automobile manufacturers at some time.

Identification. The Dana 60 can be identified by the bill of material (BOM) numbers stamped on the axle housing.

What size is a Dana 60 axle?

Dana 44 axle tube diameter ranges from 2.5″ to 3″, while the Dana 60 axle tube diameter is 3.125″. So, while the Dana 60 has a stronger housing than the Dana 44, it’s not by a massive amount, especially for the larger Dana 44s.

Is your Dana 60 standard or reverse rotation?

Most DANA 60 axles will use “Low Pinion” Standard Rotation Gear Sets but some FORD 4X4 trucks used a DANA 60 FRONT AXLE with a REVERSE ROTATION “High Pinion” Gear Set. They are also called Reverse Spiral Bevel and Reverse Cut gears. These can be identified by the pinion yoke being above the center of the ring gear.