How much pressure can an fittings hold?
How much pressure can an fittings hold?
Pressure Rating: 1500 PSI – note: crimp-on fittings are recommended for applications over 500 PSI. All of our bending line termination adaptors (45, 90, 180, etc) come with a swivel on one end so you can turn the outlet without re-installing.
What is SAE J514?
Using the example in Figure 1, SAE J514 is a specific SAE standard that covers 37 degree flare and 24 degree flareless fittings, as well as pipe fittings and adapters. Another example of an SAE standard that could be used is SAE J1453, which is used for o-ring face seal fittings.
What size is SAE 16?
SAE 45° Flare (SAE J512)
| Inch size | Dash size | Thread Size |
|---|---|---|
| 5⁄8 | -10 | 7⁄8 – 14 |
| 3⁄4 | -12 | 1 1⁄16 – 14 |
| 7⁄8 | -14 | 1 1⁄4 – 12 |
| 1 | -16 | 1 3⁄8 – 12 |
What PSI are Sharkbites rated for?
What is the maximum temperature and pressure rating for SharkBite fittings? SharkBite fittings are certified to 200 PSI and 200°F (93°C).
What size is SAE 4?
SAE 45° Flare (SAE J512)
| Inch size | Dash size | Thread Size |
|---|---|---|
| 1⁄8 | -2 | 5⁄16 – 24 |
| 3⁄16 | -3 | 3⁄8 – 24 |
| 1⁄4 | -4 | 7⁄16 – 20 |
| 5⁄16 | -5 | 1⁄2 – 20 |
What is SAE 8 thread?
SAE 45° Flare (SAE J512)
| Inch size | Dash size | Male Thread O.D. (in) |
|---|---|---|
| 1⁄4 | -4 | 0.44 |
| 5⁄16 | -5 | 0.50 |
| 3⁄8 | -6 | 0.63 |
| 1⁄2 | -8 | 0.75 |
What is SAE j1926-1 port?
SAE J1926-1 — SAE Straight Thread O-ring Port (ISO 11926-1) (Conforms to MS16142. Does NOT conform to MS33649(8).) UN/UNF Threads Table U18 — Port Detail — SAE J1926-1 (ISO 11926-1) 1) Nominal tube OD is shown for the standard inch sizes and the conversion to equivalent millimeter sizes.
What is the rated working pressure of a 37 degree fitting?
From the tables below, the rated working pressure for the -4 male 37 degree tube end is 34.5 MPa (5,000 psi) and the rated working pressure of the -6 (3/8″) male pipe end is 21 MPa (3,000 psi). The rated working pressure of the fitting would be 21 MPa (3,000 psi).
What is the rated working pressure of the hydraulic fitting?
The rated working pressure of the fitting would be 21 MPa (3,000 psi). For proper performance, the design of any hydraulic system should take into consideration the rated working pressures for each of the components of the system, including standard ratings for hose and tubing components and assemblies.
