What are stud guards for?
What are stud guards for?
Stud Guards protect pipes inside the walls from nails and screws during drywall and cement board installation. Steel stud shoes reinforce wood and metal studs where drain pipe penetrates them.
Are stud guards required?
Stud Guard Product Information: Stud Guards are a highly necessary product in a construction project. Most building codes require the use of Stud Guards to help protect pipes from nails during the sheet rock application.
What is a Halex protector plate?
Protects non-metallic sheathed cables or raceway-type wires running through wood studs, joists, rafters, or similar structural wood members from accidental nail, screw, or drill penetration. …
What is a FHA plate?
FHA nail plates are used to protect pipes and wiring running through wall studs of any building. Our nail plates can be manufactured in a wide range of sizes and hole punch patterns to accommodate any plumbing code requirement.
How do water pipes run through walls?
- Step 1: Assess and Remove the Wall. If you need to run a new stack, assess your framing.
- Step 2: Prep for New Pipe. Cut a hole with some wiggle room for the new pipe.
- Step 3: Assemble and Place Drainpipe. Assemble the approved fittings onto the top of the drainpipe.
- Step 4: Run the Vent.
- Step 5: Guide and Attach Pipes.
Do I need nail plates for electrical?
Electrical wiring is strung through holes drilled through the middle of wooden studs when constructing homes, condos, apartments and other residential structures. To add a measure of safety, nail plates should be installed on both sides of the wall stud to protect both sides of the wiring.
Are nail plates required for electrical?
It only applies to cables passing through a hole in the member. It sounds like in your case, the cables are run on top of the purlins, so technically, you do not need nail plates there.
What are nail plates?
Nail plates are flat strips of galvanised steel which have been punched to create multiple small prongs on one side. These are hammered into the surface of adjacent pieces of timber to hold them together. They are widely used in framed structures and in the prefabrication of structural elements such as trusses.
What is a nail bed?
Definition of nail bed : the vascular epidermis upon which most of the fingernail or toenail rests that has a longitudinally ridged surface often visible through the nail.
What is Boca plate?
Boca Plate Product Information: Boca Plates are primarily used to protect vertical running piping in between studs from drywall nails that could potentially puncture the piping. We offer a wide variety of lengths, widths, gauges, and hole locations to accommodate varying building codes across America.
How do you notch a stud for a wire?
There are other, less specific guidelines: When possible, notch a stud near the top, rather than the bottom. Don’t locate holes and notches near large or loose knots, and don’t group too many in the same area of the stud. Finally, notch only when necessary; holes weaken it less than notches.
