What are the dimensions of a 1310 u-joint?
What are the dimensions of a 1310 u-joint?
Understanding U-Joints
| Series | Cross Width | Cap Diameter |
|---|---|---|
| 1310 | 3.219 (3 7/32”) | 1.062 (1 1/16”) |
| 1310BC* | 3.219 (3 7/32”) | 2 @1.062 (1 1/16”) 2 @ 1.125 (1 1/8”) |
| 1330 | 3.625 (3 5/8”) | 1.062 (1 1/16”) |
| 1330BC* | 3.625 (3 5/8”) | 2 @ 1.062 (1 1/16”) 2 @ 1.125 (1 1/8”) |
How strong is a 1350 u-joint?
The 1350 U-joint is rated for 2,200 lb-ft (minimum elastic limit) of torque.
What is a 1350 u-joint?
Non-cross-drilled Heavy Duty 1350 U Joint The Thrust washers in each bearing cap is to eliminate metal on metal contact preventing wear and lower overall operating temperature. It is non-greaseable design that is factory lubed with synthetic grease for excellent friction reduction.
What is the difference between 1330 and 1350 U joint?
U-joint sizes are classified by a series number. Each series has a very specific cap diameter and overall joint width. The 1330 to 1350 U Joint cross width is 3.625 (3 5/8”) on both sides, while the cap diameters are different. 1 1/16″ on the 1330 side and 1 3/16″ on the 1350 side.
What size is a 1410 U joint?
Driveshaft and Driveline Parts > Universal Joints > U-Joints BY SIZE > 1410 Series U-Joint 4.188 X 4.188 – 1.188 outside snap ring > 1.188 X 1.188 Bearing Cap Diameter.
What is the size of a you joint on a truck?
1410 U-Joint Series is on 3/4 and 1 Ton or larger trucks. 1.188 cap and 4.187 width. (1 3/16 x 4 3/8) Inside Lock U-Joints are measured from the grooves in the caps where the C-clips fit not the overall width of the U-Joint like the outside lock type. On the left is a Pinion Yoke and UJ for inside lock. The C-clips are facing up to photograph.
What are the dimensions of a U-joint on a Chevy Tucson drive shaft?
If you have a Chevy Car DRIVESHAFT with INSIDE “C” CLIPS the u-joint dimensions should be 2.556 inches wide between inside shoulders of yoke – 1.125 bearing cap diameter You have a 3R series driveshaft …see choices below COMBINATION U-JOINTS may have been used at the rear end of some INSIDE “C” clip style OEM driveshafts.
Where is the U-joint located on a 1350 universal joint?
This snap ring centers the u-joint within the yoke ears. Typically found on 1310, 1330, 1350 universal joints. INSIDE “C” CLIP STYLE: You can easily identify the INSIDE style GM 3R series because when you look at the yoke you see the end of the u-joint bearing cap and no squeezable snap ring is visible.
How do I measure my GMB U-joints?
You can check the GMB U-joint lookup tool for a diagram on how to measure each type. The process is pretty straightforward. In the drop-down menus, enter the type and then all the required measurements. Next, take a look at the list of the available GMB U-joints that match the specs you entered (it’s at the bottom of the page).
