What axles does a 1995 Jeep Wrangler have?
What axles does a 1995 Jeep Wrangler have?
There was one and only one rear axle on the Jeep Wrangler YJ’s, all the way up until they made the Rubicon models in the TJ form, then they switched to Dana 44’s. You should have a Dana 30 FRONT and a Dana 35 REAR. I wouldn’t waste a dime on polishing up a turd.
What axles are in my Jeep YJ?
Identifying the axles in YJs is pretty simple since there were no options for it. Every YJ came with a Dana 30 up front and a Dana 35 in the rear. TJ Wranglers will have either a Dana 30 in the front and a Dana 35 in the rear unless you have a Rubicon model. In which case you’ll have 44s front and back.
Can a Dana 30 Handle 33 inch tires?
The 30 is fine up to 35″ tires without a locker before upgrades are normally needed. 33’s are as far as I would push the Dana 35. If you do more than easy-medium trails I would really look at upgrading.
What size are the axles on a Jeep Wrangler?
The width of the axle shafts is 1.13 inches. Dana 44: These are the beefier axles found on the rear of all Wrangler models now with either a 3.21 or 3.73 gear ratio. The Dana 44 ring gear size is 8 ½ inches. Rubicon models come standard with a 4.10 rear gear ratio and also use a Dana 44 axle in the front with either a 3.73 or 4.10 gear ratio.
Where can I get replacement axles for my Jeep?
Crown Automotive offers the largest line of Axle & Differential replacement parts for Jeeps. Our applications include Front Axle, Rear Axle, Yokes, U-Joints, Front Drive Shafts and Rear Drive Shafts for all Jeep® models.
What is the width of the axle shafts on a TJ?
The width of the axle shafts is 1.13 inches. The YJ Dana 30 hold a reverse cut ring and pinion, but the TJs do not. Both TJs and YJs, however, use a 5×4.5 inch bolt pattern. Dana 35: This was an axle size used on most Jeep rear axles.
What is the gear ratio on a Dana 44 Jeep Wrangler?
They came with either a 3.21 or 4.10 gear ratio. The width of the axle shafts is 1.13 inches. Dana 44: These are the beefier axles found on the rear of all Wrangler models now with either a 3.21 or 3.73 gear ratio. The Dana 44 ring gear size is 8 ½ inches.
