What does F 10 on a Kenmore oven mean?

What does F 10 on a Kenmore oven mean?

runaway temperature
If you see F10 on your range, it means that your electronic control board has detected a runaway temperature. It’s possible that your range is not heating to the temperature that you set it to, or that the control board may be reading the temperature incorrectly.

How do I reset my Kenmore oven?

How to Reset a Kenmore Elite Stove Oven

  1. Press the “7” button on the Kenmore Elite keypad.
  2. Continue holding the “7” button for at least six seconds until a single beep sounds.
  3. Press the “Start” button on the keypad once. This will reset the oven back to the factory default settings.

What does F10 error mean on a Frigidaire oven?

On most Frigidaire ranges, the F10 indicates that the control detects a runaway temperature in the oven. If this fault code appears when the oven is at room temperature, then the failure points to a failed oven temperature sensor probe circuit or a bad electronic oven control board.

What does F10 mean on Kenmore oven?

An F10 error on a Kenmore stove indicates that the temperature conditions in the oven are incorrect. Using a flashlight and a digital multimeter, you can find out what the problem is in less than an hour.

What does F10 error on my Kenmore range mean?

Kenmore Oven Error. The fault codes for the oven will appear on the display,usually in the form of a code like F10 or F91.

  • Kenmore F10 Error.
  • Troubleshooting F10 on an Oven.
  • Thermal Control Unit Damage.
  • Improper Temperature Detection.
  • What does F10 mean on oven?

    f10 means that your oven thinks that your oven sensor is shorted. This can be caused by either a bad oven sensor or a bad display relay control board. You can’t test the board but you can test the sensor. Open the door and remove the 3-4″ long thin metal rod attached to the back wall.

    What does the F2 code mean on my Kenmore stove?

    The “F2” error code indicates that the oven is getting too hot in temperature while baking or while in the cleaning mode cycle. Possible causes: High resistance in the oven temperature sensor probe or high resistance in the oven temperature sensor probe circuit.

    author

    Back to Top