What finishes can be applied to concrete?
What finishes can be applied to concrete?
Types of Concrete Finishes
- Troweled Finish. Trowel finish is the most common and popular finish of concrete used for major types of applications.
- Broom Finish.
- Stamped Concrete Finish.
- Salt Finish.
- Exposed Aggregate Finish.
- Swirl Finish.
- Polished Finish.
- Colored Finish.
What are the two stages of finishing the concrete?
Screeding (Step-1) screeding. This is the process of striking off the excess concrete to bring the top surface to proper grade.
What is a tamped finish?
A tamped finish for unformed surfaces is produced by raising and lowering the compacting beam in its final pass to produce a surface with ridges at a fairly regular spacing of 20 to 30mm and up to 5mm high.
How much does it cost to finish concrete?
To have concrete poured and finished, it will cost $2.52 to $2.60 per square foot for the labor, and $2.83 to $3.57 per square foot for the concrete itself.
What is Pan finish concrete?
This is a flat surface produced typically by power-floating but not by Basic (Skip/Easy Float) methods of surface finishing. A Pan finish will exhibit ridges (although not to the degree of Basic methods), provide a rough textured surface and will vary in consistency in its final appearance.
Can you over tamp concrete?
Over-compacting the mix can actually cause aggregate materials to separate, which will weaken the concrete.
What is brushed cement?
Brushed concrete is a type of finish for poured concrete. After pouring, the concrete is brushed with a stiff bristled broom, which gives it a rougher surface compared to smooth finished concrete. Brushed concrete is also one of the most affordable options, so it’s a great choice if you’re on a budget.
How do you smooth concrete after pouring?
Smooth the surface with a steel trowel after it’s partially hardened. Hold the trowel almost flat and swing it in large overlapping arcs while applying pressure. Float the concrete when you’re done grooving and edging (Photo 6).
How do you finish a concrete slab?
Use the metal trowel in a sweeping motion to smooth the surface of the slab, keeping the forward portion of the trowel off the concrete. Repeat process in small areas until the surface is free of ridges, peaks and holes. Float the entire slab in the same manner, checking the entire surface for a consistent texture and finish.
For a concrete floor with a basic finish, you can expect to pay $2 to $12 per square foot . If you have an existing concrete slab that’s ready for staining, polishing, or application of a decorative coating or overlay, most decorative concrete floor installations can be quite cost-effective.
Can you install hardwood floors on a concrete slab?
You CAN install hardwood floors on a concrete slab. More Info: It is possible to install hardwood floors on a concrete slab as long as you first install proper subflooring. The two most important aspects of hardwood over concrete are expansion and moisture control.
How thick should a concrete slab foundation be?
A slab foundation is a large, thick slab of concrete that is typically 4”-6” thick in the center and poured directly on the ground all at one time. The edges of the slab are thicker (as wide as 24”) in order to allow for extra strength around the perimeter.
