What is decal softener?
What is decal softener?
The GSW Decal softener is the solution for the application of decals on uneven or rough surfaces.
How do you use AK decal adapter solution?
Liquid to adapt your decals to any surface. Wet the decal with the solution and a brush after place it. Leave for a few minutes, then with the help of the brush, adapt it to the surface to fully integrate it.
Can you use Windex to apply decals?
The vinyl will not stick as well to any oil or waxy surface. Use a little rubbing alcohol to clean the area where the decal will be applied. If you’re applying the decal to glass, DO NOT use Windex or other ammonia-based cleaners; the ammonia interferes with the adhesive.
How do you apply decal softener?
With the help of tweezers and a flat brush we put the decals in the desired spot and gently we remove the excess of water. 7. Once the excess of water is removed, we apply a thin coat of Decal Softener Medium. Should be applied over the decal and let it to dry for about 2 hours.
How do you soften old decals?
Simplest solution is to tape them to a window for some days. Best bet to keep them intact is to apply Micro Liquid Decal Film by brush on each single decal, let it dry completely and only then put them in water.
How do I apply a decal to my product?
Cut out the decal to be applied. It is best to leave the carrier film intact if possible, but where this will make the decal too big for the area where it is applied, or where there is an irregular surface it may be best to cut right up to the printed decal area. Place the decal on the surface of the water and leave it for 20 or 30 seconds.
Why choose a waterslide decal for your model?
This is partly because most model kits are supplied with appropriate waterslide decals, but also because they generally work very well in most situations and it is relatively easy to get a good result. Waterslide decals can vary considerably in quality.
How long do I leave the decal in the water?
Place the decal on the surface of the water and leave it for 20 or 30 seconds. The decal may float or sink and it may curl up, none of this matters.
How do you glue the decals on the back of the model?
On top of the paper is a layer of water soluable glue. The actual markings are printed on the glue film and on top of that is a carrier film. When placed in water for a few seconds the glue will become slippery and allow the decal to literally slide off the backing paper and on to the model.
