What is duplex outlet?

What is duplex outlet?

A duplex outlet provides space for two electrical receptacles, leaving you room to plug in two devices. Whether you’re in search of a 30A, 125-Volt outlet for your washing machine or a 50A, 250-Volt outlet for your electric dryer, you are sure to find the right outlet for you at HomElectrical!

What is a lighting outlet definition?

A lighting outlet is an outlet intended for the direct connection of a lampholder, a luminaire or a pendant cord terminating in a lampholder. Every box used solely for lighting must be designed or installed so that a luminaire may be attached.

What’s the difference between an outlet and a receptacle?

In layman terms, according to the previous image, a receptacle is one set of holes where the plug of an appliance is connected, while a receptacle outlet or simply an outlet is the whole box, which may contain various receptacles.

What is a standard outlet called?

The most common electrical outlet in any home is a 110 volt. Sometimes you may hear 110 volt plugs referred to as 120 volt.

What is a 4 outlet receptacle called?

Two-duplex outlets are also referred to as quad outlets or four-plug outlets.

What is the maximum distance between receptacles on the same wall?

The maximum spacing between receptacles, according to the National Electric Code (NEC), has been set at 12-feet since 1956–with no point along a wall being more than 6-feet from a receptacle. The logic behind that number is that an appliance with a standard length cord could then be plugged-in anywhere along the wall.

Is a switch an outlet?

Switches and dimmers open and close electrical circuits to control lights, fans and other electrical devices. Just like outlets, switches have different functions and uses, so learn more before you buy.

What is NEC definition of outlet?

*According to Article 100, an outlet is defined as a point on the wiring system at which current is taken to supply equipment that utilizes electric energy for electronic, electromechanical, chemical, heating, lighting, or similar purposes [100].

What fan types are affected by Inlet and outlet conditions?

Fan types typically affected by both inlet and outlet conditions are inline fans (both axial and centrifugal) and housed single inlet centrifugal fans. Fan installations with system effects should be avoided if possible. However, in many cases space constraints or other factors prohibit designers to allow for ideal conditions.

How do you calculate outlet velocity on a fan?

Outlet velocity is calculated by divid- ing the CFM by outlet area. RPM Revolutions per minute, the number of rotations the fan shaft makes per minute. SE Static efficiency. Static efficiency is a ratio of the fan power output to the power supplied to the fan.

What happens if there is no discharge duct for a fan?

Without a discharge duct, a system effect will occur. (See figure 12 on page 4 for recommended discharge.) Inline installations are subject to system effect both at the fan inlet and outlet, as shown in Figures 5 and 6. Figure 5 illustrates a poor inlet condition with an elbow directly at the fan inlet.

How do you choose the right duct fan for your ductwork?

For instance, if the duct must turn 90º, a centrifugal fan installed in the turn could be a better choice than an inline fan with an abrupt duct elbow. Select housed centrifugal fans with the proper rotation and best discharge position for the situation.