What is route based on originating virtual port?

What is route based on originating virtual port?

The default load balancing algorithm is called “Route based on originating virtual port”. This simply means VMware vSphere will assign the virtual ports of the virtual machines to the next uplink, as illustrated in the following diagram.

What is port ID in VMware?

In a physical network device, there is port number/port ID such as Ethernet1/1, GigabitEthernet1/1. You can think port ID is like a port number but within a VDS. In vSphere 6.5 for example, maximum number of VDS ports are 60,000 https://www.vmware.com/pdf/vsphere6/r65/vsphere-65-configuration-maximums.pdf.

Which load balancing policy is available only with the distributed switch?

Route Based on Physical NIC Load This load balancing method is available only for distributed switches.

What is NIC teaming in VMware?

VMware NIC teaming is a way to group several network interface cards (NICs) to behave as one logical NIC. Properly configured NIC teams allow guest virtual machines (VMs) in a VMware ESX environment to failover if one NIC or network switch fails. VMware NIC teaming also helps load balance network traffic.

What is route based VPN?

A route-based VPN is a configuration in which an IPsec VPN tunnel created between two end points is referenced by a route that determines which traffic is sent through the tunnel based on a destination IP address.

What is Route based on IP hash?

Route based on IP Hash works by taking the source and destination IP addresses and performing a mathematical calculation on each packet to determine which uplink in the team to use.

What is Beacon probing in vmware?

Beacon probing is a network failover detection mechanism that sends and listens for beacon probe packets on all physical NICs in the team. In a teamed uplink packets will be sent through each physical NIC. Note: In ESXi 5. It uses this packet information along with link state to determine link failure.

What is the difference between VSS and VDS load balancing?

VSS and vDS represent the core of networking in vSphere and ESXi. You can use vSS on a single ESXi host, while vDS works best for larger data centers. VDS requires vCenter server for configuration but does not require it in order to run after the initial configuration.

What is network port teaming?

NIC teaming is the process of combining multiple network cards together for performance, load balancing, and redundancy reasons.

What is the difference between NIC teaming and bridging?

What is the difference between NIC teaming and bridging? NIC Teaming allows you to create a NIC interface that spans one or more NIC adapters that are all on the same subnet. NIC Bridging allows you to pair NIC adapters from different subnets to enable communication between the two subnets.

What is the difference between route based and policy based VPN?

Policy-based VPNs encrypt and encapsulate a subset of traffic flowing through an interface according to a defined policy (an access list). A route based VPN creates a virtual IPSec interface, and whatever traffic hits that interface is encrypted and decrypted according to the phase 1 and phase 2 IPSec settings.

How does policy based routing work?

Policy-based routing (PBR) is a technique that forwards and routes data packets based on policies or filters. The goal of PBR is to make the network as agile as possible. By defining routing behavior based on application attributes, PBR provides flexible, granular traffic-handling capabilities for forwarding packets.

https://www.youtube.com/watch?v=cHf33iotIYo