What is the best way to design a mousetrap car for distance?

What is the best way to design a mousetrap car for distance?

For example, old CDs make great wheels to increase distance. If your car is a rear-wheel drive car, set the wheels on a narrow rear axle so the wheels turn more and travel further. You can also increase the distance your car will travel by making the frame lighter.

How far can a mousetrap car go?

The average distance the rattap car went was 18.6875ft and the average distance the mousetrap car went was 25.5ft.

What are some features of a mousetrap car made for speed?

Common Design Elements of a Speed-Trap Racer

  • high torque gearing.
  • shorter length lever arm.
  • smaller diameter drive wheels.
  • wheels with good traction.
  • reduced friction bearings.
  • light weight components.

Is it better to have a heavier or lighter mousetrap car?

A heavy mousetrap vehicle will required more pulling force than a lighter mousetrap vehicle in order to achieve an equal acceleration. Lighter mousetrap vehicles will require less energy at the start and can use longer lever arms for more pulling distance.

Where should I place the mousetrap for the best performance for distance?

For optimal performance the mouse trap should be positioned on the chassis so that the tip of the lever arm falls directly above the drive axle when the mouse trap is in the fully wound position (as pictured bellow). If the mouse trap is not aligned properly with the drive axle energy will be wasted off the start.

How far did the world record mousetrap car go?

182 meters
Description: The secret to Doc Fizzix’s world record setting mousetrap distance racer that traveled over 182 meters was it’s unique pulley system. This is the same pulley set-up that was used on Doc Fizzix’s world record setting mousetrap distance car.

How do you make a mouse trap car?

Put the large wheels on the back of the car, opposite the snapper arm. Wrap a small rubber band around the axle on either side of each wheel so the wheels can’t fall off. Tie a string very tightly to the snapper arm on the mouse trap. The string should be long enough to just reach to the back axle.

How to make a mousetrap car?

Materials

  • Car Body. Take the 2 pieces of cardboard (about 4”x10”) and cut a rectangular notch (about 1”x2“) in the center of the short side of each piece of
  • Attach the Straws.
  • The Mousetrap.
  • Preparing the Wheels.
  • Adding the Axles and Wheels.
  • Attaching the Hook to the Rear Axle.
  • You’re Done!!!
  • What is the physics behind a mousetrap car?

    Physics behind. Teachers use mousetrap cars to help students better understanding on some primary concepts of physic through hands-on experience learning. Forces; One of the foundation concepts of physics, a force may be thought of as any influence which tends to change the motion of an object.

    How does a mousetrap run a car?

    Determine the distance for which the data will be collected. T ear off enough ticker tape to cover the distance of the timing.

  • Select or determine the frequency of the ticker timer. The frequency of the ticker tape determines the time between each mark.
  • Label one end of the tape as the front.
  • Place your vehicle at the start line.
  • author

    Back to Top