What is the default password for Juniper?

What is the default password for Juniper?

Juniper Router Login Guide The default username for your Juniper router is netscreen. The default password is netscreen.

What is the default root password for Juniper SRX?

no password
After installing the SRX Series device, log in as the root user. There is initially no password for the root user. After you initially log in as root, the shell prompt (%) appears.

How do I reset my juniper srx550?

By default, pressing and holding the RESET CONFIG button for 15 seconds or more—until the STATUS LED blinks red—deletes all configurations on the services gateway, including the backup configurations and rescue configuration, and loads and commits the factory configuration.

How do I access Juniper CLI?

To log in to a device and start the CLI:

1. Log in as root . The root login account has superuser privileges, with access to all commands and statements.
2. Start the CLI: root# cli root@> The > command prompt shows that you are in operational mode. Later, when you enter configuration mode, the prompt will change to #.

How do I log into my juniper switch?

Connecting and Configuring an EX-series Switch (CLI Procedure)

1. Connect the console port to a laptop or PC using the RJ-45 to DB-9 serial port adapter.
2. At the shell prompt type ezsetup.
3. Enter the hostname.
4. Enter the root password.
5. Enter yes to enable services like Telnet and SSH.

How do I change the root password on a Juniper SRX?

Step-by-Step Procedure Type the set command for the plain-text password and press Enter. [edit] user@host# set system root-authentication plain-text-password New password: Type the new password next to the New password prompt and press Enter.

How do I reset my juniper to factory settings?

Restore Juniper SRX210 to factory default configuration

1. Power on the Juniper SRX210 by plugging it to the power adapter.
2. Using a pin or paperclip, press and hold the RESET CONFIG button for 15 seconds.
3. Wait about 2 minutes while the Juniper SRX210 restores to the factory default settings.

How do I reset my juniper switch to factory settings?

Reverting to the Default Factory Configuration by Using the Menu Button

1. Press the Menu button until you see MAINTENANCE MENU on the panel.
2. Press the Enter button.
3. Press Menu until you see FACTORY DEFAULT.
4. Press Enter. The display says RESTORE DEFAULT?
5. Press Enter.

How do I change the root password on a Juniper switch?

To set the root user password with a plain-text password:

1. Select Configure>System Properties>System Identity.
2. Click Edit.
3. In the Root password box, type the password for the root user.
4. In the Confirm password box, type the root password again.
5. Click OK.