What is the G2 on a deer?
What is the G2 on a deer?
G1 refers to the first point on an antler. This is typically the location of the brow tine (if the brow tine is missing, the G1 is missing). G2 is the next tine, then G3, and so on (see photo above). A normal 8-point buck would have a G1, G2, and G3.
Why are deer tines called G?
On the whitetail score sheet, A is for the greatest spread, B is for the number of points, etc. G simply was in order for the data of tine length.
How are deer antlers scored?
Boone and Crockett white-tailed deer antler score represents a sum of antler lengths, point lengths, circumferences and inside spread measured in inches to the nearest ⅛ inch. Length of a point is measured along the outside center of a point between its tip and base.
What are the antlers on a deer called?
Antlers, which are often called a “rack,” are made of bone, much like our fingernails. But unlike fingernails, they’re grown only by bucks. Female deer, called does, seldom grow antlers.
What is a good antler score?
For a typical whitetail, meaning the antlers are symmetrical, the minimum score is 125 inches. A non-typical whitetail must have a minimum score of 155 inches for entry. A typical mule deer has to tape out at 145 inches or greater, while a non-typical muley is eligible at 170 inches.
What does unbranched antler mean?
An unbranched antlered buck is any buck deer with an antler having no more than one point. If the one antler is unbranched then yes, take him.
Why do female deers not have antlers?
Why do Some Female Deer Grow Antlers? Although the male buck produces testosterone, which is essential for antler growth, some female deers produce this. An antlered doe rarely occurs because of an imbalance in the hormones that cause higher testosterone levels.
What is a G2 on a buck?
G2 is the next tine, then G3, and so on (see photo above). A normal 8-point buck would have a G1, G2, and G3. A normal 10-point buck would have a G1, G2, G3 and G4. The end of the main beam IS NOT referred to as a G, although it does count as a point.
What does G1 mean on a deer antler?
Gs – The letter G is used to name normal antler points. G1 refers to the first point on an antler. This is typically the location of the brow tine (if the brow tine is missing, the G1 is missing).
Where is the G2 ranch?
Located just 15 miles outside of Pearsall, Texas, the G2 Ranch offers a hunting experience like no other.
What does G1 G2 and G3 mean?
This is typically the location of the brow tine (if the brow tine is missing, the G1 is missing). G2 is the next tine, then G3, and so on (see photo above). A normal 8-point buck would have a G1, G2, and G3. A normal 10-point buck would have a G1, G2, G3 and G4.
