What is the pass acronym for fire extinguishers?
What is the pass acronym for fire extinguishers?
Pull, Aim, Squeeze, and Sweep
It’s easy to remember how to use a fire extinguisher if you can remember the acronym PASS, which stands for Pull, Aim, Squeeze, and Sweep. Pull the pin. This will allow you to discharge the extinguisher. Aim at the base of the fire.
Can spraying someone with a fire extinguisher?
Direct contact of the skin with the pressurized CO2 can cause frostbite. The damage to the skin can be limited to mild redness, but blisters are also possible. Damage to the eyes can also occur with direct exposure. If you suspect someone has inhaled spray from a fire extinguisher, get them to fresh air immediately.
What are the four golden rules of using fire extinguishers?
Using the correct type of extinguisher for the fire, use the four-step PASS technique.
- Pull: Pull the pin, this will break the tamper seal.
- Aim: Aim low, pointing the nozzle or hose at the base of the fire.
- Squeeze: Squeeze the handle to release the extinguishing agent.
Which two steps are part of the PASS method?
P.A.S.S. the Fire Extinguisher
- Aim: Aim the nozzle of the fire extinguisher low at the base of the fire.
- Squeeze: Squeeze the trigger you just pulled the pin out of. Remember to squeeze it slowly and evenly, so it is as effective as possible.
- Swipe: Swipe from side to side to cover all areas the fire may have spread to.
How do you use a fire extinguisher safely?
- PULL… Pull the pin. This will also break the tamper seal.
- AIM… Aim low, pointing the extinguisher nozzle (or its horn or hose) at the base of the fire.
- SQUEEZE… Squeeze the handle to release the extinguishing agent.
- SWEEP… Sweep from side to side at the base of the fire until it appears to be out.
How do you extinguish a fire on someone?
How to put out a fire on someone? The basic principle when someone catches fire is “stop, drop and roll”. It helps them to extinguish the flames on themselves. If you are near someone on fire and they stop, drop and roll – you can then smother the flames in a wet blanket or a coat.
What is CO2 extinguisher?
CO2 fire extinguishers contain pure carbon dioxide which is a clean extinguishant, leaving no residue. Suitable for class B flammable liquid fires (petrol, oil, solvents), and recommended for use on live electrical equipment.
What is a good technique when using fire extinguisher?
When operating a fire extinguisher, tell residents to remember the word PASS: Pull the pin. Hold the extinguisher with the nozzle pointing away from you and release the locking mechanism. Aim low. Point the extinguisher at the base of the fire. Squeeze the lever slowly and evenly. Sweep the nozzle from side-to-side.
What is the pass method for fire extinguishers?
The PASS Method. To use a fire extinguisher correctly, follow the “PASS” method, which are 4 simpe rules recommended by firefighters on how to use use a fire extinguisher properly. PASS is an acronym for: Pull the pin from the fire extinguisher.
What does pass stand for in a fire extinguisher?
The ‘PASS’ system stands for Pull, Aim, Squeeze and Sweep. It describes the stages in which a fire extinguisher should be operated and explains what each stage entails, giving enough information for the operator to use the extinguisher safely.
What is the pass technique for fires?
The PASS Fire Extinguisher technique should be common knowledge to EVERYONE! PASS is the acronym used to describe the four essential steps of operating a fire extinguisher. The first step is to pull the pin at the top of the extinguisher. The pin is in place to prevent the handle from being accidently pressed.
