What is the size of the overhang at the gable end walls?
What is the size of the overhang at the gable end walls?
Gable end overhangs that are ladder framed should not extend more than 8 inches from the house and should be nailed every 4 inches on center.
Do you need a header on a gable end wall?
You do not need a header in a gable wall unless there is a point load supporting the ridge beam. But there are two other openings in that gable wall where he was legally required to add a header to the framing.
How do you attach F channel?
Hold the first strip of F-channel against the siding along the top edge of the chalk line. Position the F-channel upside-down, with the slot facing the F-channel that is nailed to the fascia board. Drive nails through the slots in the F-channel and into the side of the house every 6 to 12 inches.
How do you retrofit a gable end?
framing is provided by a wood gable end wall truss or a conventionally framed rafter system. The retrofits are appropriate for wall studs oriented with their broad face parallel to or perpendicular to the gable end surface. Gable ends to be strengthened shall be permitted to be retrofitted using methods prescribed by provisions of this section.
What is the best way to frame a gable roof?
If the house is in a hurricane-prone region or other high-wind area, determine the framing approach based on the length of the gable roof overhang. Ladder framing and outrigger framing are the two most common methods. Outrigger framing, using outlookers, is recommended for overhangs greater than 12 inches deep.
How do you make a gable look like an angled soffit?
This allows the gable projection of the eave to extend down and look like an angled soffit at a glance. While flat soffits are not ideal, one way to mask them is to stop the horizontal soffit at the gable-end wall, as in the previous example, and then add a decorative bracket at the gable end to hide the transition from flat to angled.
What size gable soffit-Nailer do I Need?
If the eave overhang is more than 2 feet, an extra rung which bears on the lower end of the gable truss is needed for support. Gable Soffit-Nailer: If the eave soffit is to slope, a 2″ x 4″ gable soffit-nailer is required at the lower end of the panel.
