What is the torque setting for wheel nuts?
What is the torque setting for wheel nuts?
New wheels should be re-torqued after the first 50 to 100 driving miles.
| Hardware Bolt or Stud Size | Typical Torque Range in Ft/Lbs | Minimum Number of Turns of Hardware Engagement |
|---|---|---|
| 12 x 1.5 mm | 70 – 80 | 6.5 |
| 12 x 1.25 mm | 70 – 80 | 8 |
| 14 x 1.5 mm | 85 – 90 | 7.5 |
| 14 x 1.25 mm | 85 – 90 | 9 |
How do you determine torque settings?
Calculate Torque
- Fill your values into the equation T = K x U x D x P.
- Solve the equation T = 1.33 times 0.20 times 0.50 inches times 13,927 lb. The total is 1,852 inches lbs.RE. Reduce the value into ft-lb. You can do this by dividing your value by 12, the number of inches in a foot.
What does NM mean on a drill?
Torque, measured in Newton Metres (Nm), is the force that causes an object to rotate and is the best gauge to see how powerful your drill or impact driver is and the higher the number in newton metres the more twisting force it will deliver.
How much torque is too much?
Most 2WD road cars – even with large grippy tires – can’t handle more than 400-500 lb/ft of torque. AWD cars can handle as much as 600 lb/ft without losing traction.
How much torque do I need to torque my lug nuts?
Torque the lug nuts in two steps, starting at 40 ft/lbs of torque for your first step to get the wheel seated properly. Then for the final torque refer to our chart below for torque recommendations based on your lug nut thread size. Be sure to follow the torque sequence shown above for your specific lug count. Wheel Lug Nut Torque Specs
What is the torque for a 12mm bolt?
What is the torque for a 12mm bolt? Bolt Size 8.8 10.9 6mm (M6) 9Nm 13Nm 8mm (M8) 23Nm 33Nm 10mm (M10) 45Nm 65Nm 12mm ( M12) 80Nm 115Nm
How do you find the torque specs on a metric bolt?
Metric Bolts Maximum Torque, in foot-pounds, for clean, dry threads Check your Shop Manual ! how do you find the torque specs on a bolt? Begin with the formula T = K x U x D x P, where T is the torque, K is a standard representing 1.33, U is the coefficient of friction, D is the diameter of the fasteners, and P is the necessary preload.
How do you calculate torque from recommended torque?
* If lubrication has been applied to the bolt and/or the nut (other than the normal protective oil film), multiply the recommended torque by the appropriate factor shown in the table. Example: bolt and nut are both phosphated; required torque = torque recommended x 0.75.
