What weight should I use for Pinewood Derby car?
What weight should I use for Pinewood Derby car?
Below are several suggestions for adding weights to your pinewood derby car.
- Zinc Top Weight.
- Lead Wire Weights.
- Tungsten Weights.
- Tungsten Canopy.
How do you distribute the weight on a Pinewood Derby car?
Best Location to Weight Your Pinewood Derby Car When deciding on where to weight your car, you should try to reach a final balance point of the car 1 inch or less in front of the rear axle. To achieve this, place 2/5 of the added weight behind the rear axle, and the remaining 3/5 in front of the rear axle.
Does weight matter Pinewood Derby?
This means that mass of the car does not matter. It also says the car’s final speed only depends on the starting height.
Where do you put weights on a derby car?
Weight should be placed towards the rear of the car. You can drill the weight holes in the bottom, side or rear of the car as shown in these examples. Stay at least 1/8″ away from the axle slots.
Where is the best place to place a weight on a Pinewood Derby car?
rear
Weight should be placed towards the rear of the car. You can drill the weight holes in the bottom, side or rear of the car as shown in these examples. Stay at least 1/8″ away from the axle slots.
How much does a Pinewood Derby car weight out of the box?
about 3.5 ounces
How much does a Pinewood Derby car weigh out of the box? The official Pinewood Derby car weighs about 3.5 ounces without any modifications. The wooden block is about 3.3 ounces, and the wheels and axles add about 0.2 ounces.
Why does adding weight to a Pinewood Derby car make it go faster?
Simply put: the more weight you can shift towards the rear of the car, the more potential energy it will have. The key important term is POTENTIAL. It is believed that the more stored energy you have, the faster your car can travel.
How much does a pinewood derby car weigh?
Pinewood Derby Car Weights. The more your pine car weighs, the faster it will go on a downhill ramp. Most rules specify a 5 oz. maximum weight. Most Pinewood Derby cars weigh between 1.5 oz and 3.5 oz (depending on design) without weights so a car may need 3.5 oz or more of additional weight.
Where should the center of gravity be on a pinewood derby® car?
Putting Pinewood Derby® Car Weight randomly on your PWD car is not the key to getting the most out of your build. Center of gravity placement should be between 1⁄2″ – 1″ in front of the rear axle. This is true for all wheel base types. Whether you are using a standard wheelbase or an extended wheelbase.
How do you put weight on a pine car?
Drill one or more 9/32 ” holes in the back, bottom or side of your pine car, insert the weights in the holes then glue them into place or cover with wood putty. The package comes with 3 sections for a total of 3 oz.
