What would cause a Chevy Cobalt not to start?
What would cause a Chevy Cobalt not to start?
The most common reasons a Chevrolet Cobalt won’t start are a dead battery, an alternator problem, or failed starter.
How do you reset the anti-theft system on a 2006 Chevy Cobalt?
To perform a reset of the 2006 Chevy Cobalt theft system, turn the ignition key to position and wait for approximately 10 minutes for the flashing anti-theft goes off. Next turn the key off and then go back to the car and start it. But why is a theft system so important.
Where is the starter located on a Chevy Cobalt 2007?
The starter on the 2007 Chevy cobalt is located inside the steering column and is connected to the ignition where you put the keys in.
How do you reset the computer on a Chevy Cobalt?
To reset the computer disconnect both cables from Your battery and place them together. This will allow all the electricity stored in the system to drain out. You will want to allow them to be disconnected for at least ten minutes. This usually will fix the computer system and allow it to completely reboot.
How much is a starter for Chevy Cobalt?
Chevrolet Cobalt Starter Replacement Cost Estimate. Labor costs are estimated between $70 and $89 while parts are priced between $231 and $438. This range is based on the number and age of Chevrolet Cobalt’s on the road.
How do you reset theft mode?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How much is a starter for a Chevy Cobalt?
How much is a 2008 Chevy Cobalt starter?
Compare with similar items
| This item New Starter Replacement For 2008-2010 Chevy Cobalt 2.0L 2.2L 2.4L, 08-11 HHR, 2014 Impala 2.4L, 08-14 Malibu 2.2L 2.4L, 10-16 Equinox 2.4L 8000213 8200213 89060407 | |
|---|---|
| Customer Rating | 4.4 out of 5 stars (157) |
| Price | $6495 |
| Shipping | FREE Shipping. Details |
| Sold By | OEG Parts |
How do I reset my cobalt TCM?
To reset the TCM, I turn the key to the ON position, step on the accelerator pedal for 10 seconds, turn off the engine, release the accelerator pedal and wait 5 minutes for the engine to restart.
