Popular guidelines

When selecting the large displacement option solidworks simulation does what?

author 0

When selecting the large displacement option solidworks simulation does what?

The large displacement solution assumes that the stiffness changes during loading so it applies the load in steps and updates the stiffness for each solution step. When Large displacement is selected in the Static dialog box, the static study is solved by stepping the load and updating the geometry.

What is a large displacement?

Activate the Large displacement option and try again in the following cases: If displacements of the contacting faces are noticeable when you plot the deformed shape using a scale factor of 1.0. If the highest strain exceeds 4%. If von Mises stresses are close to yield.

How do you turn on large displacement in Solidworks?

To activate the Large displacement option:

  1. In the Simulation study tree, right-click the static study icon and select Properties. The Static dialog box appears.
  2. On the Options tab, check Large displacement.
  3. Click OK.

What are the benefits of distributed coupling for Pins & Bolts?

The introduction of distributed coupling enhances the formulation of pin and bolt connectors. Distributed coupling allows the faces attached to pin and bolt connectors to deform, which delivers a more realistic representation of a connector’s behavior.

How does solidworks measure deflection?

You can perform deflection and stress calculations on structural steel cross sections. Click Beam Calculator (Toolbox toolbar) or Toolbox > Beam Calculator . In the Beam Calculator dialog box, select a Load Type. Under Type of Calculation, select Deflection or Stress.

What is deformation scale in Solidworks?

The deformation scale refers to the scale factor that the program uses to scale the deformed shape of the model. A larger deformation scale factor helps you visualize deflections that are a lot smaller compared to the original dimensions of the model.

How do you turn off large displacements in Solidworks?

In the Simulation study tree, right-click the static study icon and select Properties. The Static dialog box appears. On the Options tab, check Large displacement. Click OK.

How do you do a static analysis in Solidworks?

To perform static analysis:

  1. Create a static study.
  2. Define material for each solid, shell, and beam.
  3. Define restraints.
  4. Define external loads.
  5. For assemblies and multibody parts, use component contact and contact sets to simulate the behavior of the model.
  6. Mesh the model and run the study.
  7. View the results:

How do I change the scale of a Simulation in Solidworks?

To change the model scale: Click File > Print3D….Changing the Model Scale

  1. Type a value for the scale factor.
  2. Click Scale to Fit to apply the maximum scale factor.
  3. Click Orient to Fit and Scale to Fit.

author

Back to Top