Where is the best place to put the weight on a Pinewood Derby car?
Where is the best place to put the weight on a Pinewood Derby car?
rear
Weight should be placed towards the rear of the car. You can drill the weight holes in the bottom, side or rear of the car as shown in these examples. Stay at least 1/8″ away from the axle slots.
Is it better to put weight on top or bottom of pinewood derby car?
When the paint has dried, mount the weight on the top of your car as far to the rear as possible. The weight should not extend past the rear of the car. Glue bottom weights to the bottom of the block to bring the total weight (including wheels and axles) to 5 oz.
How do you increase the speed of a Pinewood Derby car?
5 Quick & Easy Tips For Improving Your Pinewood Derby Car’s Speed
- Put all of your weight in the back.
- Lube the car at the body/wheel friction point.
- Spend a fair amount of time on axle prep.
- Make sure your wheels are ready.
- Finally, once your wheels are mounted, check their alignment.
What is the ideal weight for a pinewood derby car?
5 ounces
First, the basics: Your car should weigh as much as it’s allowed. In most races, a Pinewood Derby car’s weight is limited to 5 ounces. If your car weighs less than that, add coins or other weights.
What is the maximum weight for a Pinewood Derby car?
MAX OUT YOUR CAR’S WEIGHT AT 5 OZ In most races, a Pinewood Derby car’s weight is limited to 5 ounces. If your car weighs less than that, add coins or other weights.
Where’s the best place to add weight to a pinewood derby car?
Placing weights on a Pinewood Derby car toward the rear of the body is often the only practical place to add weight. The narrow nose section doesn’t allow adequate space for weights, especially internally.
Where to put weights on Pinewood car?
Your Pinewood Derby car should balance about 1″ to 1 1/2″ in front of the rear axle. This means that you should put weights near the back of the car. The rear axle should be as close to the back of the block as possible.
What is the weight of a derby car?
The maximum weight limit for a pinewood derby car is 5.0 ounces. Your car should weigh 5.0oz to be competitive. The car block weighs between 1.5oz and 3.5oz (depending on your car design), so plan on adding roughly between 1 and 3 ounces, which allows .5oz for wheels and axles.
