Where is the filling loop on a Worcester combi boiler?

Where is the filling loop on a Worcester combi boiler?

Repressurise a Boiler with a Keyed Internal Filling Loop This could vary depending on your boiler, but on a Worcester Bosch model, the port is located to the front, right hand side.

How do you pressurize a Worcester combi boiler?

External Filling Loop

  1. Attach the hose to each side of the valve and open the mains cold tap.
  2. Open the second tap which allows water in to the heating system.
  3. Watch the pressure rise and stop once the bar reaches just about one and turn off both taps.

How do you Repressurise a boiler without a filling loop?

You need to find the hot water cylinder Opening this valve while monitoring the pressure on the boiler will add extra water to your hot water tank. The tank forms part of your overall heating system, and so topping it up will increase the pressure in the system, and therefore repressurise your boiler.

Do all combi boilers have a filling loop?

For the most part, you can tell by what type of boiler you have. For example, combi boilers usually have internal filling loops, so there is no installation necessary. Your plumber or heating engineer should have that taken care of for you.

How do I know if my filling loop is closed?

Filling loops can come in different designs and can be detached from the boiler when not in use. With the black levers in this position the valves are OFF/CLOSED. Find the filling loop and check that both ends are securely attached.

How to repressurise a Worcester combi boiler?

Here are the steps to repressurise the Worcester combi boiler using an internal filling key. ⭐ Step 1: Locate the internal filling key properly and place it accordingly. Check under the Worcester combi boiler, and you will find out a white plastic tray. Then, you will just need to locate the key by removing the tray. ⭐ Step 2:

Where is the filling key on a Worcester combi boiler?

Locate the internal filling key properly and place it accordingly. Check under the Worcester combi boiler, and you will find out a white plastic tray. Then, you will just need to locate the key by removing the tray. Check out the white arrows which are pointing upwards close to the base of the key.

How do I fill the external filling loop on my boiler?

External Filling Loop 1 Attach the hose to each side of the valve and open the mains cold tap. 2 Open the second tap which allows water in to the heating system 3 Watch the pressure rise and stop once the bar reaches just about one and turn off both taps 4 Remove the taps from the hose, there will be some water drip out so be mindfull More

How do I open the mains cold tap on my boiler?

Attach the hose to each side of the valve and open the mains cold tap. Locate the key this will usually be on a flap underneath the boiler or it may have been provided you as part of the installation

author

Back to Top