Where is the hall sensor on LG washer?
Where is the hall sensor on LG washer?
The hall sensor is mounted on the stator, on the back of your motor. In most cases, you can access the stator by unplugging the washer and removing the rear panel of your machine to expose the motor.
Why does my LG washer always say UE?
The uE and UE error codes on your LG top-load washer both mean the washer won’t run the spin cycle because the load is unbalanced. The UE error code appears if the rebalance routine fails to evenly distribute the load after 3 attempts and the control board stops the washer.
How do you clear the CL code on a LG washing machine?
CL Error Code It is an indicator that the child lock feature is set active. When the child lock feature is active, the control panel will be disabled and settings cannot be adjusted. To fix this: Press and hold the child lock button for 3 seconds.
Why does my washer keep getting off balance?
Laundry caught below the tub or between the agitator and the inner tub can cause the washer to operate off balance with every load. The problem can be anything: a penny that worked its way out of a pocket, a button that fell off a shirt or a wayward sock or other article of clothing.
How do I replace the Hall sensor on my LG washing machine?
Part link for the Hall Sensor (standardized for all LG models; includes a video showing how to replace it) ==> Hall Sensor 1. Unplug the power cord. 2. Remove the rear washer panel. 3. Locate the Hall sensor connector on the stator behind the rotor. 4. Place the meter leads on terminals 5 to 4,white to gray. 5.
What are the symptoms of a Bad Hall sensor on LG washer?
A common symptom of a bad Hall Sensor in your LG washer is the LE error code ( read more ). A disconnected or damaged motor harness and even a bad main control board can cause the LE error, too, so you may want to check the Hall Sensor itself to see if it’s working.
What causes LG front load washer error code Le?
As most professional Appliantologists know, the infamous LE error code in LG front-load washers is usually caused by a bad hall sensor, also called a rotor position sensor or RPS. The hall sensor is easy to test and replace.
How do I test the Hall sensor?
To measure output signal voltage from the Hall Sensor, carefully move test leads to terminals 4 (gray) to 1 (blue). Slowly rotate the motor rotor by hand. You should read a pulsing 10 VDC. If 10VDC is measured from 4 to 1, move the lead on the blue wire to the red wire, terminal 2.
