Where is the reset button on a Whirlpool refrigerator?
Where is the reset button on a Whirlpool refrigerator?
Open the refrigerator’s door and look for the door switches. Press the door switches and the refrigerator temperature button three times within 10 seconds. After releasing the switches, there should be a letter “S” display in the freezer section and an “E” in the refrigerator’s display.
How do you reset the compressor on a Whirlpool refrigerator?
4 steps to reset a refrigerator compressor
- Unplug your refrigerator.
- Turn off the refrigerator and freezer from the control panel.
- Reset your freezer and fridge temperature settings.
- Wait for the refrigerator temperature to stabilize.
Why won’t my fridge get cold but freezer works?
When the fridge is not cold but the freezer is, the problem is probably tied to one of your refrigerator’s mechanisms not working as designed. A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer.
What is wrong when your refrigerator not cooling?
Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). To do this, unplug the fridge and pull it out. Clean the fan blades and spin the fan by hand to see if it’s stuck.
What to do if fridge is not cooling?
Depending on the cause of your refrigerator not cooling, the following procedures might help.
- Make sure your fridge is getting power.
- Take a look at your owner’s manual.
- Check the refrigerator thermostat.
- Test the seals on your fridge doors.
- Determine whether the refrigerator is level.
- Clean the condenser coils.
Why is my freezer cold but fridge warm?
It is standard to find that most refrigerators use a fan to move cold air that is in the freezer into the evaporator. Then that air is pushed into the refrigerator area to keep it at a cool temperature. When this fan is not functioning properly, your freezer may seem fine, but your refrigerator will seem warm.
Why the fridge is not cold but the freezer is?
Why did my refrigerator stop cooling?
Problem: Fridge Not Cooling Be sure the fridge is plugged in and getting power. Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan).
Why is my general electric refrigerator not cooling?
If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. The condenser fan motor draws air over the condenser coils to cool them. The condenser fan motor is located underneath the refrigerator near the back.
Why is my Whirlpool refrigerator not getting cold?
If the evaporator fan is not working, it will not circulate the cold air to the refrigerator compartment. If this occurs, the freezer may still get cold, while the refrigerator will not get cold. To determine if the evaporator fan motor is defective, try turning the fan blade by hand.
Why is my Whirlpool refrigerator leaking water?
Re: water leaking from whirlpool gold refrigerator. When refrigerators leak water it usally is a sign that the defrost drain found inside the rear of freezer and behind the rear panel of freezer has become clogged with ice or gunk. Sometimes the pan below refrigerator has a crack and allows water to leak onto floor.
How do you troubleshoot a whirlpool refrigerator?
Troubleshooting a Whirlpool refrigerator begins with checking the power cord. Plug in the power cord, or try another port if the cord is plugged in well. Check if the refrigerator door fails to close completely or if it fails to open normally. Examine and set the temperature of the refrigerator accordingly.
https://www.youtube.com/watch?v=OQydo7GodA8
