Why is my ABS light on in my 2002 Ford Explorer?
Why is my ABS light on in my 2002 Ford Explorer?
The speed sensors attached to the front wheel bearings are only there for the ABS. So if you have an ABS light with no other lights or symptoms its very likely one of the front sensors has failed. In addition to ABS the rear sensor also powers the speedometer.
Will a wheel sensor turn on the ABS light?
Your computer can usually detect this with sensors, and will turn the ABS light on if it finds it. Wheel speed sensors are a piece of equipment that tells your computer how fast each wheel is turning independently.
What does the ABS light on a Ford Explorer mean?
Then, attach and mount a new sensor. You may still need to reset the computer again via the method described above. Step Three: If the light still comes on, you should use an ODB code reader to diagnose the problem, as the vehicle believes there is still a problem warranting the light.
Why is my ABS brake light and traction control light on?
When the ABS and Traction Control lights illuminate, it is typically due to a faulty wheel or speed sensor or an ABS module failure. An OBDII scanner can read trouble codes stored in the ECU, but you need a mechanic to test these codes to identify the cause and corresponding fix for the issue.
What does the ABS light mean on a Ford Explorer?
The ABS light in a Ford Explorer comes on and stays on when there is a problem with the brake system or in cases where spark plugs are wearing thin. This light indicates there is an issue with stopping power that generates issues when trying to stop rapidly or in bad weather.
Why does my Ford Explorer ABS light stay on?
Here are the three most common causes of the ABS light coming on: Wheel Speed Sensor The wheel speed sensors are responsible for monitoring the wheel speed and sending it back to the computer system. ABS Module The antilock brake system runs through the ABS module. ABS Fluid Level
How do you reset the ABS light?
Locate the DIC control panel on the dashboard in front of the driver’s seat under the speedometer. Keep pushing and releasing the “Set” button on the DIC control panel until “ABS” is shown. Hold the “Set” button for about 5 seconds to reset the light and turn it off.
Why does the ABS light come on?
The two reasons for an ABS light to come on are to test the function of the bulb or to warn the driver that some type of fault has occurred in the anti-lock brake system. Some of the common reasons for an ABS light to come on include: Standard bulb check. Low fluid.
