Why is my DVD player saying no disc?
Why is my DVD player saying no disc?
The message DISC ERR is usually displayed when the unit ca see the disc but not play the disc. This usually occurs when the disc is scratched or dirty. The message NO DiSC is displayed when the unit simply can not read or detect the disc at all. This can also occur if the disc is scratched or dirty.
How do I reset my CD player?
How to reset the CD player.
- Unplug the power cord of the CD player from the AC wall outlet.
- Allow the CD player to set without power for 30 seconds.
- Plug the power cord of the CD player back into the AC wall outlet.
How do you fix a DVD player that won’t spin?
You may need to open the case of the DVD player and apply WD-40 or similar lubricant into the motor and drive shaft. Before you do this, make sure it will not void the warranty. 4. If the disc is scratched or damaged in any way, the DVD player spins then stops, or the DVD player spins but won’t play.
Why is CD player not working?
If a CD player does not work at all, make sure the power supply is on at the outlet. Check the electrical cord and replace it if necessary; remove the housing and test the fuse; test the on-off switch and replace it if needed. If a CD player skips, check to be sure the CD itself is not scratched or dirty.
How do I turn on a CD player?
Insert a CD into the disc slot, label side up. Do not press the [CD ] button while CD is being inserted. This could cause an injury and damage to the front panel. Press the [DISC] button for less than one second to switch to the CD player mode.
Can I clean CD player lens with alcohol?
NEVER alcohol or any other fluids. Simply fog the lens with breath, then gently spin a cotton swab sideway on the lens surface.
What are the symptoms of a CD player not working?
A typical symptom is you insert a disc in the player and after a while; the CD tray opens again with the message referring to no disc being in the system. This can be infuriating because you can see that there is a disc, however, the CD / DVD player cannot.
If you are getting a NO DISC error on a CD / DVD player, then chances are the laser has failed. A typical symptom is you insert a disc in the player and after a while; the CD tray opens again with the message referring to no disc being in the system.
How do you fix a CD player that won’t turn on?
Unplug the power cord of the CD player from the AC outlet for 30 seconds. Plug the power cord back into the AC outlet. Turn on the CD player and attempt to play the disc. If the issue is still not resolved, remove the disc and unplug the power cord from the AC outlet.
Why won’t my CD burner play my CD?
The playback of discs created with a CD burner cannot be guaranteed. If CDR or CDRW discs are being used, attempt to playback a commercially produced CD. If the issue is not resolved, attempt to play a different commercially produced CD.
