Why is my freezer working but my fridge is warm?

Why is my freezer working but my fridge is warm?

The most common cause for this condition is a problem with the defrost system. If the refrigerator freezer is cold but the refrigerator is warm, the evaporator fan motor might have failed. Every refrigerator has a set of coils called an evaporator. These are the coils that get cold.

Why my Maytag fridge not cooling but freezer is?

When your Maytag refrigerator freezer is cold but refrigerator is warm dirty condenser coils are a common reason why. Turn off power to the refrigerator. Locate condenser coils, removing bottom or top grille as needed. Use the brush attachment of a vacuum to gently vacuum the coils.

Why is freezer working but not refrigerator?

When the fridge is not cold but the freezer is, the problem is probably tied to one of your refrigerator’s mechanisms not working as designed. A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer.

Is there a reset button on Maytag refrigerators?

There is no reset button on Maytag fridges. To reset any Maytag fridge model, you will need to use a combination of keys.

How do you fix a Maytag refrigerator that is not cooling?

1. The Refrigerator isn’t cooling or is too warm

  1. Adjust the temperature.
  2. Check the settings.
  3. Check if vents are obstructed.
  4. Make sure the icemaker is turned on.
  5. Check if the water line is kinked.
  6. Make sure water shut-off valves are fully open.
  7. Make sure the door is sealed properly.
  8. Wipe down the door seal gasket.

How do I put my Maytag refrigerator in test mode?

Enter the Service Test Mode by performing the following sequence of events.

  1. Open the Fresh Food door and press and hold the Door Alarm keypad DoorAlarm .
  2. Press and hold Refrigerator Temperature UP keypad .
  3. Release the Door Alarm Keypad DoorAlarm and wait 3 seconds.
  4. Press the Refrigerator UP Keypad again.

How do I reset my Maytag freezer?

Press and hold the buttons for 8 to 10 seconds to reset the display. The refrigerator display can be reset by pressing and holding the energy save and lighting button for 10 seconds.

How do you put a Maytag refrigerator in diagnostic mode?

Where is the evaporator fan located in a Maytag refrigerator?

This evaporator fan motor is located in the back of the freezer. This part circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated throughout your appliance.

Why is my Maytag refrigerator not cooling?

My Maytag Refrigerator is not Cooling. Common solutions for: My Maytag Refrigerator is not Cooling. 01 – The Evaporator Coils are Frosted Over. The defrost heater assembly turns on a few times throughout the day to melt away any frost that may have accumulated on the evaporator coils.

Where can I get help with my Maytag refrigerator?

Even if you don’t have a Maytag, search the Maytag ® refrigerator help page to find answers to your issues. If you do have a Maytag ® refrigerator and need professional repair help, call 1-800-344-1274 to schedule service. HOW DOES A REFRIGERATOR WORK?

How long does it take for a refrigerator to cool down?

If it’s just been installed, you’ve recently loaded in a lot of food or the doors have been opened a lot that day, you may need to wait up to 24 hours for the temperature to drop back down. If not, run through these other steps to narrow down the cause. The recommended temperature for the refrigerator is 37°F and the freezer 0°F.

What does the thermistor do on a whirlpool refrigerator?

The thermistor monitors the refrigerator temperature and sends the temperature reading to the control board. The control board then regulates power to the compressor and evaporator fan based on the thermistor readings. If the thermistor is defective, the compressor and evaporator fan may not run when necessary, or may run too frequently.

author

Back to Top