What is the CPT code for laparoscopic tubal ligation?

What is the CPT code for laparoscopic tubal ligation?

58670
2.2. 8.4 Tubal Ligation Procedure code 58600, 58615, 58670, or 58671 may be reimbursed for tubal ligations.

What is the ICD 10 code for tubal ligation?

Z98.51
Tubal ligation status. Z98. 51 is a billable/specific ICD-10-CM code that can be used to indicate a diagnosis for reimbursement purposes.

What is the difference between CPT code 58571 and 58552?

58552 is a LAVH. Lap Assisted Vaginal Hysterectomy and the 58571 is for TLH, Total Laparoscopic Hysterectomy. You need to read the op ntoe to see what was done. If they do everything through the scope but just remove the uterus through the Vaginal then go with 58571.

Does CPT 58605 need a modifier?

You can report the tubal ligations following a vaginal delivery (59400, 59409-59410). If the tubal ligation occurs immediately after the delivery (during the same operative session), use 58605 with modifier 59 (Distinct procedural service) appended.

What should I expect after a tubal ligation?

After Surgery. You may have increased cramping and vaginal bleeding for a day or two after the procedure. You may experience gas pains for about a day or so due to gas administered during the procedure. This may extend into your upper abdomen and shoulder. Walking will help relieve this pressure.

What does CPT code 58670 mean?

The Current Procedural Terminology (CPT) code 58670 as maintained by American Medical Association, is a medical procedural code under the range – Laparoscopic Procedures on the Oviduct /Ovary.

What to expect after tubal ligation reversal?

Tubal Reversal: What to Expect Before, During, and After Surgery. When you awake, you can expect to feel a bit groggy, due to the anesthesia. Dr. Morice will review how the procedure went with you. You may experience mild pain, cramping, and soreness. If you drove from less than 4 hours away, you and your guardian can then drive home for recovery.

What are the three methods of tubal ligation?

Tubal ligation methods. Tubal ring The silastic band or tubal ring method involves a doubling over of the fallopian tubes and application of a silastic band to the tube. Pomeroy tubal ligation In this method of tubal ligation, a loop of tube is “strangled” with a suture. Usually, the loop is cut and the ends cauterized or “burned“.

https://www.youtube.com/watch?v=GxRJH2f–P0

author

Back to Top