Useful tips

How do I cut in Sketchup?

author 0

How do I cut in Sketchup?

To perform a trim, follow these steps:

  1. Select the Trim tool ( ). Tip: Until you hover over a solid group or component, you see an arrow cursor with a circle and a slash.
  2. Click to select the cutting group or component.
  3. Click the group or component that you want to cut.

What material is mirror?

glass
A mirror is typically made of glass with a flat or curvy surface, and has a reflective covering over it. Mirrors aren’t only for appearance; they are also used in many technological and scientific components. Before mirrors were manufactured, pools of water were often used to see a reflection.

How do you make a cone in Sketchup?

Creating a cone

  1. With the Circle tool, draw a circle.
  2. Use the Push/Pull tool to extrude the circle into a cylinder.
  3. Select the Move tool ( ).
  4. Click a cardinal point on the top edge of the cylinder, as shown on the left in the figure.
  5. Move the edge to its center until it shrinks into the point of a cone.

Can you see reflections in a mirror in SketchUp?

It is common for interior designers to incorporate mirrors and create effects of reflections and glare. While SketchUp does not allow you to see reflections in a mirror, there are some tricks to simulate this.

How do you make a reflection of a mirror?

When you want a reflection either on a shiny ground or from an actual mirror just flip your geometry and place a transparent color in the face of the mirror to create this illusion.

How do you Mirror an object in Photoshop?

Next you need to copy that object. The quickest way to duplicate this is to use the CTRL + Move. With the duplicate positioned you can then Scale negatively to mirror the original object.

How do I Mirror an object with the scale tool?

To mirror an object with the Scale Tool you will need to select the object first. It can be raw geometry, grouped geometry or components. Next you need to copy that object. The quickest way to duplicate this is to use the CTRL + Move. With the duplicate positioned you can then Scale negatively to mirror the original object.

author

Back to Top