How do you flatten wine bottles?
How do you flatten wine bottles?
Sprinkle a little bit of salt on the tray to hold the bottle in place and then place the bottle with the label up on the tray. Close the toaster oven and set the temperature for 200 degrees. Wait for two hours. After two hours have passed, turn the temperature up as high as it will go (but do not set to broil).
How do you make a Japanese wind chime at home?
How to Make Japanese Wind Chimes
- Drill a small hole in the top of the bell, large enough to accommodate the cord you’ll be slipping through it.
- Attach the wooden or metal rod to the cord.
- Insert the other end of the cord through the hole in the bell, tying a knot at the top so it won’t slip through.
What can you make with bottle cap?
18 Bottle Cap Art Projects & Craft Ideas
- Bottle Cap Ladybugs. This is a cute and easy way to use up old bottlecaps and it’s a great project for kids to take part in.
- Magnets.
- Bottle Cap Necklaces.
- Ornaments.
- Mini Pincushion.
- Bottle Cap Spiders.
- Earrings.
- Bottle Cap Coaster.
How do you make a wind chime out of a bottle?
Hold the bottle up by the chain and note where the key ring sits inside. Measure from this point down to about 1 inch (2.5 cm) from the bottom edge of the bottle. Cut a second piece of chain according to that length. The wind catch is the little ornament that dangles from the bottom of the wind chime.
How do you add a second chain to a wind chime?
Add the second chain to the key ring inside the bottle. Reach into the bottle and pull out the key ring. Thread the end of your second chain onto this key ring, then hold your wind chime up again. You will have 2 chains in your bottle. The first chain should be sticking out of the top of the bottle.
How do you decorate a porch with wind chimes?
Wind chimes are a pretty way to decorate your porch. When the wind blows, they will make a gentle tinkling noise. While you can always buy one from the store, making your own wind chime is easy. All you need is a glass bottle, some ornaments and key rings, and a bit of chain or cording.
How do you draw a bottle with spirals?
The easiest way I could think of to draw straight lines for the spirals around the bottle was to place some tape on the bottle then trace that for the line. I used one piece of tape and moved it for each spiral. I sectioned it off into 4 equal spirals. With the lines marked it was time to score the bottle to start the cracks.
